Structure Problems of Suzuki XL7

Suzuki XL7 owners have reported 20 structure related problems since 1996. Table 1 shows the 4 most common structure problems. The number one most common problem is related to the vehicle's body (9 problems). The second most common problem is related to the vehicle's structure (5 problems). For details of each of the problem category, use the links in the table.

Table 1. Structure related problems of Suzuki XL7

Problem Category Number of Problems
Body problems
9
Structure problems
5
Paint problems
4
Door problems
2

Recently reported Structure problems of Suzuki XL7

The Body problem

Takata recall for my carrier bearing or my midship bearing where it mounts to the sheet metal is starting to crack and give out and cracking causing a lot of vibrations at slow speeds   Read details...

The Structure problem

April 21st 2008 we had taken my vehicle to medved in wheat ridge, CO. Where they had did a diagnostic test and they had decided that they would replace the sensors, 4-low switch, and transfer case module. They had kept the vehicle until may 2nd, 2008. Mid may 2008.   Read details...

The Paint problem

My 2008 Xl7 has had many problems in the last couple of years. The sunroof has kept leaking into the cabin lights and into the driver's side ceiling requiring 2 visit to a body shop to fix the seal. My transmission control required replacing due to my car jerking between 2nd and 3rd gear.   Read details...

The Door problem

Was told that I was hearing a noise that wasn't there when the rack n pinion started to fail. And that the dash board was suppose to crack. I really don't have enough characters to tell you how unsafe this car is so I'll just give you a list.   Read details...




Fuel Economy of XL7 Vehicles
XL7 Service Bulletins
XL7 Safety Recalls