Wiring Problems of Toyota Scion Xb

Toyota Scion Xb owners have reported 5 problems related to wiring (under the electrical system category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Toyota Scion Xb based on all problems reported for the Scion Xb.

1 Wiring problem of the 2008 Toyota Scion Xb

Failure Date: 12/01/2011

The initial incident occurred while driving the vehicle on partially snow covered pavement. As I applied the brakes to stop stop at an intersection, the vehicle began to skid. The vehicle stability control and abs systems did not work, and the brake, abs and vsc lights came on. The warning lights remained on for approximately one day as I continued to drive. After the warning lights turned off, they remained off for approximately two weeks, then the abs and vsc systems failed again and the lights came back on. This problem occurs fairly regularly, six to eight times per year. I was quoted a cost of around $1200 to replace the rear hub assemblies and wiring harness replaced, with no guarantee that would solve the problem.

See all problems of the 2008 Toyota Scion Xb 🔎.

2 Wiring problem of the 2008 Toyota Scion Xb

Failure Date: 09/13/2011

The contact owns a 2008 Scion Xb. The contact stated after having his vehicle in for routine service check the mechanic advised him that the wiring harness on the front driver and passenger side needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and he was waiting for a response from them. The failure and current mileage was approximately 90,000.

3 Wiring problem of the 2008 Toyota Scion Xb

Failure Date: 12/16/2010

The contact owns a 2008 Scion Xb. The contact stated that the wiring harness corroded causing the electrical system to malfunction. The contact took the vehicle to a dealer who stated that the warning harness needed to be replaced. The contact stated that the wiring harness should not have corrosion on it since that was a serious safety issue. The dealer stated that the corrosion was due to salt. The wiring harness was not replaced. The failure mileage was 27,900. Updated 3/1/11 updated 05/23/11.

4 Wiring problem of the 2008 Toyota Scion Xb

Failure Date: 07/14/2010

I own 2008 Scion Xb which currently has 87000 miles on it. 4 weeks ago today I was pulling out of my driveway and from 1st gear to second gear the car jerked hard and all vsa, abs, check engine lights came on, and car wouldn't shift out of gear and steering began to act funny. I had vehicle towed to mechanic in fear of driving it ant further. Mechanic ran diagnostic on car and code read transmission sensor no good. They replaced and problem is still occurring, lights on as well. Mechanic had 3 other mechanics come and evaluate and as well inquired with local Toyota dealership who suggested only that it may be wiring harness below battery which is a recurring problem, also that they would gladly look at the car for 90 per hour! mechanics looked at harness and all looked to be in good working shape. The car is still parked and not repaired 4 weeks later.

5 Wiring problem of the 2008 Toyota Scion Xb

Failure Date: 12/28/2009

The contact owns a 2008 Toyota Scion Xb. The contact started the ignition. Immediately, the anti-lock brake system (abs), visibility stabile control (vsc) and traction control warning light indicators illuminated on the instrument panel. The warning light indicators remained illuminated until the engine was turned off. The vehicle was taken to an authorized dealer for inspection. The technician stated the failures were contributed to the speed sensor and wire harness corrosion. The vehicle has not been repaired at this time. The failure mileage was 90,000.


Other Common Electrical System related problems of Toyota Scion Xb



Safety Ratings of Scion Xb Cars
Scion Xb Service Bulletins
Scion Xb Safety Recalls