Ignition Module Problems of Buick Enclave

While in motion vehicle check engine light will come on with the following messages. Stabilitrack off, traction control off, engine power reduced. Car will not accelerate above 40 mph. Car will slightly shake while this happens. Car will some times also shut off completely and not restart until codes have been cleared. This has happened on several occasions starting in February 2017. I have been told it needs a new wiring harness, new powertrain control module, new fuse box due to water intrusion, water is stated to come from cracked windshield but windshield has been replaced before and problem persisted. Fuse box has been replaced. Pcm and ignition switch have both been replaced. Gives code p1682 which is ignition 1 switch circuit 2 code. Two document #s have shown up when running diagnostic check (4583190 and 4184289).

See all problems of the 2014 Buick Enclave 🔎.

While driving engine turned off on 4 separate occasions in the past 2 weeks. Never any warning lights or check engine light just engine turns off suddenly. The first time I was driving on a busy city road middle lane at 25-45 m/hr. No power steering or brakes. Unable to restart I was able to push into a parking lot and call for help, it was towed to my mechanic who said rollover switch tripped. 2 days later engine turned off again while exiting highway at the same speed but was able to restart in neural after a min stopped, I drove it straight to my mechanic who reset computer and drove it around for 3 days unable to diagnose problem on computer. 2 days later while driving 45 m/hr engine turned off again. I was on a small decline 2 lane busy road and able to restart in neutral position. A few times in the past few weeks vehicle would not start after parked for a few hours but would start in neural eventually after many attempts, 12/24/2016 while driving on a busy 2 lane street in town engine stopped again no power steering or brakes at 20 m/hr. Unable to restart and passengers had to get out of my Buick and push into nearest parking lot. Unable to restart, towed on 12/26/2016 to local Buick dealership to be diagnosed by a certified dealership per the suggestion of Buick USA. They can not find a problem per computer diagnosis and are trying to tell me there is some water damage behind dash on fuse block that will cost me thousands of dollars to repair but no guarantee that that is the problem I have never had any problems with lights, radio , ac or any other electrical issues that would lead me to believe that the fuse block has water damage. . Per gm forums there are many issues with ignition switches or ignition control module . Could this be the problem . My engine turning off while driving is a real safety concern and how do I resolve this problem.

See all problems of the 2008 Buick Enclave 🔎.