Frame And Members Problems of Chevrolet Colorado

The contact owns a 2009 Chevrolet Colorado. The contact stated while the vehicle was being serviced, the mechanic became aware that the entire sub frame was extremely rusted and notified the contact. Additionally, the leaf spring on the driver’s side was also extremely rusted. The sub frame was not replaced, and the vehicle was not repaired. The manufacturer was made aware of the failure and determined that the VIN was not included in a recall. The failure mileage was approximately 88,000.

See all problems of the 2009 Chevrolet Colorado 🔎.

The contact owns a 2012 Chevrolet Colorado. The contact stated that while inspecting the vehicle, it was discovered that the driver’s side subframe had fractured due to rust and corrosion. The contact indicated that the fracture was located by the bed of the truck and the cabin of the vehicle. The vehicle was inspected by a welder who advised that the damaged was too severe to repair and that the subframe needed to be replaced. The manufacturer and local dealer were notified of the failure, but no assistance was offered. The failure mileage was 157,000.

See all problems of the 2012 Chevrolet Colorado 🔎.

The contact owns a 2008 Chevrolet Colorado. The contact stated that her son informed her that the frame was corroded. The dealer was made aware of the failure and informed the contact that she needed to pay out-of-pocket for the diagnostic testing. The vehicle was not diagnosed nor repaired. The manufacturer was made aware of the failure and transferred the contact to the dealer. The failure mileage was 109,221.

See all problems of the 2008 Chevrolet Colorado 🔎.

Tl the contact owns a 2005 Chevrolet Colorado. While driving 5 mph and making a left turn, there was an abnormal bumping noise coming from the steering wheel. The contact coasted the vehicle into a parking lot and noticed that the front driver's side tire was leaning out. The contact removed the tire and noticed the entire frame was corroded through the front driver and passenger sides. The vehicle was towed to the contact's residence. The vehicle was not taken to a dealer or repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 141,000. The VIN was not available.

See all problems of the 2005 Chevrolet Colorado 🔎.

I own a 2007 chevy Colorado. I am very careful when it comes to my vehicles maintenance and take all precautions. When it comes down to a simple routine such as tire rotation, as many americans with the know how do, I performed this myself. With a four way and a torsion bar set at the factory 100 lb setting. Before I even used the torsion bar, the wheel stud had broken with no more than 30lbs of pressure. I took my vehicle to a local gm dealer and was told it is not covered under my warranty. I argued that regardless of who had worked on it, the stud still would have broke. So now I am driving around with a missing stud and I am concerned about the safety of my vehicle. I believe that this is a poorly produced part and should be replaced by my factory warranty.

See all problems of the 2007 Chevrolet Colorado 🔎.

I own a 2006 Chevrolet Colorado with 14,000 miles on it. I have taken my truck to the dealer on at least 5 occasions complaining of a terrible vibration. The vibration is horrible from 40-55+ miles per hour. The dealer has so far replaced the 2 front tires, replaced the air inside the tires, rotated the tires and most recently stated there is nothing else they can do. After the last visit, I said there is something wrong with the truck and you or gm are going to have to step up and do something. This is my only transportation and I am very nervous about driving the truck with this terrible vibration. Please let me know what else I can do. I think a recall is in the cards, either to replace the all the tires or make modifications to the truck frame, etc.

See all problems of the 2006 Chevrolet Colorado 🔎.