Five problems related to door hinge have been reported for the 2002 Chevrolet S10. The most recently reported issues are listed below.
Third door handle/latch keeps breaking making this door unusable. This handle has been replaced three times and is now broken again. Anyone using the jumpseat would be trapped in the vehicle and/or have a very difficult time exiting the vehicle in an emergency.
I own a 2002 Chevrolet s-10 with 72,000 miles. Since purchasing the vehicle, the door hinge pin bushings have failed, resulting in the vehicle doors falling out of alighment and opening while driving. The dealership, and gm, while acknowledgeing the design flaw have failed to do anything. I have researched this problem on the internet and have found in to be a wide spead situation with all gm medium duty door hinges. This problem started with the introduction of the welded door hinges rather that the bolt on type. This seem to be a very serious safety concern to me, and I cannot understand why gm is not willing to fix this problem.
The driver's side door is loose. One can literally jiggle the door approximately half of a centimeter up and down. The auto dealership in portland, maine (forest city Chevrolet - now called quirk Chevrolet) advised me that they could fail my inspection a couple of years ago - that there had been reports of this and what the progression would be of such. The door did not jiggle at all during that time and was operating properly. It did pass maine's tough inspection law during said initial notification by the dealer (inspected by vip auto, south portland, maine).
I have a 2002 chevy s-10 pick up (zr2) and the drivers door hinge is separating from the weld causing the door to be approximately 1 inch out of alignment and getting worse. I currently have 41,000 miles on this vehicle and it is out of warranty.
The door opened fine all day and all of a sudden when I went to open the door it opened only 2 inches. It appears that the front right fender panel has slid back towards the door approx. 1/2 inch and that is what's blocking the door. Upon further inspection the hinge is slightly bent. Dealer is trying to say that the door was sprung. Witnesses that I have including 2 police officers can state that this did not happen. They can state that the door opened fine the first 2 times and then not at all later. Body shop mechanic slid something inside the door hinge and popped it open resulting in the paint on the hinge to be scraped off. This should have been a warranty issue but the dealer refuses to fix it without payment. I feel since this did not happen by cause or fault of me nor was this vehicle hit on the driver side, that it is a defect and needs to be investigated. ***dimsii ivoq entry posted after 12-12-02 cut over to artemis***762999.