Car Will Not Start Problems of Chrysler Concorde

The contact owns a 2001 Chrysler Concorde. While driving various speeds at night, the headlights intermittently illuminated. In addition, the vehicle failed to start and had to be jumpstarted. The vehicle was taken to an independent mechanic, mike caboone, who diagnosed that the wiring in the light failed and needed to be replaced. The contact was informed that the vehicle was not safe to drive. The vehicle was not repaired. The manufacturer was made aware of the failure, but did not offer assistance. The approximate failure mileage was 174,878.

See all problems of the 2001 Chrysler Concorde 🔎.

When driving on highway and now back roads, car will stall without warning. No noise, sound, or smoke. Lose all power. Very dangerous condition because I must pull over immediately. I lose all engine power and car will not restart. Took car to my own mechanic and two "five star" Chrysler dealers. Nobody can figure out what is wrong. Dealers tout the expertise of their factory-trained technicians. Their able-bodied mechanics ran thorough diagnostics and assured me they tested every part they could think of. One dealer even called Chrysler directly for assistance. Nothing shows up on dealers' diagnostic equipment. My on-board computer is not coding any malfunctions. My car has left me stranded on the highway 3 times at night and two additional times on back roads. This problem occurrs without warning and it could happen anywhere, including a busy intersection. I seem to have a vehicle with an inherent, defective flaw that the best Chrysler mechanics with the best training and diagostic equipment cannot find. This is an expensive and, more importantly, a dangerous problem.

See all problems of the 1998 Chrysler Concorde 🔎.

1996 Concorde rack and pinion failed and been replaced at least 3 times. ***** the transaxle leaked, the battery was replaced, because the vehicle would not start and the multi-function switch was replaced.

See all problems of the 1996 Chrysler Concorde 🔎.

Vehicle will not start in cold temperatures, approximately 10 degrees. No codes are stored, drb ii shows no error codes and there is no spark and no gas. When temperatures warm to around 20 degrees vehicl will start.