Brake Sensor Problems of Chrysler Pacifica

Tl- the contact owns a 2017 Chrysler Pacifica. The contact stated that while in reverse the vehicle suddenly went into self parking mode and crashed into a second vehicle. After the incident the contact noticed the self parking sensor light was illuminated. Also during the incident the pre collision braking system did not activate to prevent the vehicle from crashing into the second vehicle. No injuries were reported and no police report was taken. The vehicle was taken to the local collision center and the manufacturer was notified. The vehicle was later examined by the manufacturers engineer who indicated pre collision braking system had failed. The pre collision braking system module was replaced and the failure was remedied. The local dealer orange coast Chrysler located 2929 harbor blvd, costa mesa, CA 92626 was also notified of the failure. The failure mileage was 10,000. Jft.

See all problems of the 2017 Chrysler Pacifica 🔎.

On Tuesday 7/31/18, as I was slowing down to turn onto a neighborhood street, the electronic stability control active warning light came on, a warning that lane assist was unavailable flashed on the dashboard, and the blind spot sensors on both side mirrors turned on with a warning message that the blind spot assistance was unavailable. After about an 1/8th of a mile, I slowed to a stop sign and the brakes started to feel tight as if they were locking. The screen on the dashboard went blank and the gauge speedometer was not registering. I was able to make a slow left turn and then an immediate right turn into a driveway, but as I came to a stop the brakes were completely locked up and nothing was working as if the engine had turned off. I had to restart the vehicle twice for the dashboard to come back to normal. Had u64 - reprogram powertrain control module and u50 manual park release recalls performed 7/25/18.

Tl- the contact owns a 2018 Chrysler Pacifica. The contact stated that while driving at 60 mph, while approaching a vehicle the forward collision warning system failed to alert, with no warning light illuminated and no warning sound. The vehicle was taken to huntington Jeep Chrysler Dodge ram dealership located at 1220 e jericho turnpike, NY 11743 (631) 673-0270 where the sensor was recalculated. However the repair did not correct the failure. The manufacturer was notified of the failure and did not offer further assistance. The approximate failure mileage was 810. Aw.

See all problems of the 2018 Chrysler Pacifica 🔎.

Since I purchased this in 2008, I have replaced the axle, 2 wheel bearings a few months ago, a few years ago 1 abs sensor was replaced via warranty but they wouldn't replace the other - which went out 2 months later. They knew it was going to. I replaced the transmission 2 years, the fuel pump & catalytic converter last year, just replaced the oil pan gasket 2 months ago, the radiator 2 weeks ago due to coolant lead, and now the water pump is leaking coolant. This is just what I can think of off the top of my head. It has been one problem after the other with this vehicle and I have spent a fortune on it. I can't afford to replace it & my VIN doesn't show up on the recalls.

See all problems of the 2005 Chrysler Pacifica 🔎.

On September 15th I was taking my son to school when all of my idiot lights came on and stayed on. Once I got back home and turned the car off I noticed that something was still running. After opening the hood I realized it was my abs system that want shutting off. I was able to disconnect the sensor but have been too fearful to drive it since then. My father ran a code checker and nothing was showing up except the fuel cap (which was replaced but still showing that warning light). He drove the car and noticed that the speedometer wasn't working.

See all problems of the 2007 Chrysler Pacifica 🔎.

Parking brake lining became completely unbonded from parking brake shoe. We stopped driving the vehicle until it could be diagnosed and repaired. Safety implications unknown. The mechanic who repaired the problem said he had seen a similar case where the abs sensor was damaged/disabled.

See all problems of the 2006 Chrysler Pacifica 🔎.

In the past two years I have had to replace the abs vehicle sensors on my Pacifica three times. . . Even the dealer service tech says this should be a recall.

Faulty abs and traction control sensor on 2005 Chrysler Pacifica. Both lights are on. Called Chrysler, they say they have not heard any complaints! I am the second owner, but the first sensor was replaced at 18,000. This seems to be widespread, and I am surprised Chrysler is not recalling this, especially since this is also a safety issue. I did a quick search for "abs sensor traction control Chrysler Pacifica" and found quite a few excerpts from websites. I have them in an excel file--I would like to send them to you. Let me know an e-mail address. Updated 09/18/07.

Three of four abs wheel sensors have failed in last 6 months. Thousand of sensors are on backorder from Chrysler.

The contact owns a 2005 Chrysler Pacifica. While driving on the road on October 4, 2005 went to hit the brakes and pushed the pedal as far as it would go, had no brakes. Had to swerve out of the way to get out of the middle of the street. Had to put on the emergency brake to stop the vehicle. The car was 6 months old. It was the second time this happened. 4 sensors on car, 2 out of 4 sensors tore. The contact took vehicle to the dealer, and the dealer did fix the vehicle which was still under warranty. No police reports. No crashes.