Dodge Caliber owners have reported 2 problems related to o2 sensor (under the electrical system category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Dodge Caliber based on all problems reported for the Caliber.
I purchased this 2007 Dodge Caliber rt awd in Dec of 2012. The dealership grand Chrysler Dodge Jeep in lowell, michigan on main st, reported to me the consumer, before purchase, at my request, a vehicle history stating 1 owner vehicle with no accidents. Thank god I did get the warranty because less than 14 days fresh off the lot, the vehicle loss all power and barely driveable, the car, while I was driving it, on the highway around 55 to 60 mph, lost speed real quickly and and could barely drive it to get it off the road. The vehicle coded at service shop 02 censors and catillatic convertor, the vehicle was at the dealer service dept and back and forth from my home for more than a month, until finally the Caliber had to be seen by a service representative from Chrysler/Dodge and now pushing 2 months without the vehicle not only did the 02 sensors and catillatic convertor had to be replaced, but the computer too. Got the vehicle back drove it 3 months and the vehicle had grinding in the front end,electrical seat heating and blinkers systems were malfunctioning, each tim the engine light came on and the vehicle remained sluggish and unsafe to drive, but the dealership lacked concern and made me drive it in the unsafe condition from west olive michigan to lowell. Oct 2014 the vehicle almost caused me to get into a serious rear end accident. I was driving 60mph on the highway and it went from 60 mph to 10 mph just like that cars on the highway swirved to miss hitting me and I was almost rear ended. The car completely stalled. A gentleman stopped to help me push it off the road. . Vehicle and I sat for alomost an hour waiting for tow service. Service dept. Coded the vehicle with a crank shaft censor problem and a recall as well for the front end cross member rusts out and cause bad settling and excessive tire pressure from the errosion not supporting the sub frame.
See
all problems of the 2007 Dodge Caliber
🔎.
While operating the 2008 Dodge Caliber 2. 0l engine at approximately 45mph, the car instantly stopped without applying the brakes. Then the car would go from 7mph to 50mph in a rapid acceleration and then back down to 7mph. This was rather dangerous as I was almost rear ended numerous times despite having my emergency signal flashing lights on as well as driving in the far right lane. The car also experienced excessive back firing and one loud explosion sounded as if it occurred in the catalytic converter directly underneath the car. I was lucky enough to find an auto parts store last night and was able to have the tech there use the odbii reader and it indicated the error p0132 which is the oxygen sensor as the failing unit. The failure of the oxygen sensor nearly resulted in an accident as the Dodge Caliber was almost impacted by other cars in traffic as the other cars were not prepared for the Dodge Caliber to rapidly decelerate from 45mph to 7mph. The part was replaced ASAP the next day with bosch part # 15124 and upon testing for 20 minutes the car operated without error. I called Dodge to inquire about a recall or warranty work and they declined both. In regard to public safety, I request that a case be opened to investigate this situation and others like it. The desired outcome is to have Dodge recall the O2 sensors as this type of failure can be catastrophic when traveling on the highway at higher speeds with traffic.
See
all problems of the 2008 Dodge Caliber
🔎.