304 problems related to front suspension upper ball joint have been reported for the 1999 Dodge Durango. The most recently reported issues are listed below.
The contact owns a 1999 Dodge Durango. While changing the brakes on the vehicle, the contact noticed that the upper ball joints were loose. The dealer stated that the VIN was not included in NHTSA campaign id number 04v596000 (suspension:front:control arm:upper ball joint). The vehicle has not yet been repaired. The failure and current mileages were 39,000. Updated 01/14/09. Updated 01/21/09.
Upper ball joints have too much play and need replacement.
For my 1999 Dodge Durango the ball joints need to be replaced costing $800. I see that Dodge recalled the 2000 - 2003 Durango's for this issue, or at least the upper ball joints. I don't understand why 1998 and 1999 were not recalled as well. Especially since this is a safety issue that could cause loss of vehicle control at high speeds.
My 1999 Dodge Durango has been making strange creaking noises for some time. Every time I have taken it in for service, I've been told everything is okay. Just recently those creaking noises became worse. This time when I took the car in for service I found out it was a problem with the ball joint. It was recommended that I have it fixed as soon as possible. It cost $635 to fix.
1999 Dodge Durango ball joint problem at 67,000 miles, my Durango needs balls joints. It looks like they had a recall on 2000 and up but it looks like the problem existed in 1999 also. I would like to see this model year recalled also.
Worn out upper balljoints at 80,000 miles on my 1999 Dodge Durango.
- the contact owns a 1999 Dodge Durango with a current and failure odometer reading of 96000 miles. The contact's vehicle experienced the same problems as mentioned in recall 04v596000 concerning suspension:front:control arm:upper ball joint. The contact called the local dealer, but they said that this vehicle was not covered because it was made at a different plant.
1999 Dodge Durango upper ball joint failure.
: the contact stated while driving various speeds on the highway, there was a popping noise coming from both front wheel wells. The contact inspected the vehicle and determined the left front upper ball joint was excessively worn and dry from a lack of lubrication. There was a NHTSA recall, # 04v596000, regarding the upper ball joints. The vehicle was not included in the recall due to the VIN. The manufacturer was not alerted.
I recently put new tires on my 1999 Dodge Durango, then I went to have the front end aligned only to be told they can't do it because the ball joints are bad. I notice there is a recall on 2000-2003 Durangos,yet I have the same problem. This is a family car and my children are not safe. There should be a recall for this problem on all Dodge Durangos as it is more widespread than the Chrysler corp. Realizes. Please do some thing to fix this immediately.
: the contact stated there was a noise coming from the front end of the vehicle at various speeds. The vehicle was seen by an independent repair shop. Upon initial inspection, the upper control arm ball joint were loose and needed to be replaced. There is a NHTSA recall campaign id # 04v596000 regarding the upper ball joints. The vehicle has the same problems as indicated in the recall. However it is not included in the recall due to the VIN. Updated 05/16/2006.
Suspension:front:control arm:upper ball joint excessive wear as in 2000 model year NHTSA campaign id number : 04v596000. This Durango has 85561 miles which is below the 100,000 mile cut off for the recall mentioned above for the 2000 model year. The upper ball joints on both sides show excessive wear and will separate just as the upper ball joints on the 2000 model year. I am having them replaced however, the 1999 model year should have been included in the NHTSA campaign id number : 04v596000.
Ball joints. I have been having trouble with my ball joint every since I owned this vehicle. And I believe that my vehicle should have been included in the upper ball joint recall but it wasn't. My upper ball joint don't have any grease fitting so therefore when they dry out it causes them to pop and go bad all over again.
: the contact stated there was a squeaking noise coming from the front end of the vehicle at any speed. The dealership determined the upper ball joints needed to be replaced.
: the contact stated after driving the vehicle for an extended period of time at an average highway speed, it was discovered the right front wheel was loose to the touch and pivoted to the side. The vehicle was seen by an independent repair shop. The repair shop suggested replacing the front upper ball joints. There is a NHTSA recall, # 04v596000, regarding the front suspension. The vehicle has the same problems as indicated in the recall; however it is not included in the recall due to the VIN.
Upper ball joints dangerously loose on 99 Durango. Current recall needs to be extended to the 1999 model year as they have the same problems. These upper ball joints on both sides were close to complete failure which would have caused total loss of control of vehicle had I not been in the habit of checking them because of so many reported failures of ball joints on the Durangos.
Unusual tire wear and noise from driver's side tire area for last several months. Premature severe failure of driver's side upper ball joint and lesser failure of passenger side upper ball joint. Both upper ball joints were replaced and realigned.
Told ball joints very bad in my 1999 Durango . Chrysler states my Durango is not on their list so I'm out of luck even though they know their ball joints are defective. Repair costs are mine they aren't responsible. If there is another recall they may reconsider. If they have defective parts should they not be held responsible or do I have to be injured or killed first.
I have a 99 Durango that is making excessive noise coming from the front ball joints. I have had the car checked, and the problem is definitely from the front ball joints. I have been told my vehicle is not covered by this recall. If Dodge is truly concerned about driver safety, why do they limit the recall? if its a safety issue because of defective parts, then why don't they agree to review the vehicle? what recourse do I have?.
Ball joint failure in my 1999 Dodge Durango. I have to replace ball joints in my 99 Durango, why are they not recalled like the 2000 model they have the same exact problem.
Bad ball joints 57k miles.
Took in for routine maintance. Found out that upper ball joints were ready to braek at 51,000 miles. This is on my 1999 Dodge Durango that hasd been well taken care of. Caught the problem before failure occured which would have caused steering failure. Ball joints and lower control arms needed replaced. Yes the old parts are available.
Contact states while driving there was a ticking noise. Service dealer stated the left front ball joint needed to be replaced.
I noticed while driving my 1999 Dodge durrango, at speeds in excess of 45 mph, that the front end shook excessively. I took my 99 durrango to the local Dodge dealer, and asked about a recall that I was told about. The service manager at the dealership told me it was for 2000's not 99's. Then he proceded to tell me that the 2000 and the 99 upper control arm and ball joint assembly were exactly the same part. But, he could not explain to me why one was covered under the recall and the other was not. He then quoted me a price and wanted me to leave my vehicle so it could be repaired. When I insisted on an explaination for this, he swiftly gave me a 1-800 number to call, where ofcourse I got the run around and still no answer.
Contact states: premature wear of upper ball joints and front suspension. Dealer t said car was not under recall. Also, called daimler Chrysler and they told him the same thing.
1999 Dodge Durango. Ball joints and tie rod needed to be replaced because they were completely broken. I saw the recall notice on the 2003 Durango and believe that my 1999 Durango experienced the same failure.
Dt consumer states when the wheel was turned to the right, the vehicle would jerk and pull to the right. The vehicle has been serviced. The upper ball joint were replaced to correct this problem.
Consumer states: on the front end driver's side, the lower and upper ball joints were bad and had to be replaced. The boot was completely blown out. It was making a squeaking noise and had a different drive.
Ea03023 ball joints on the 1999 Dodge Durango. Consumer wants to know why there are no recall on the 1999 Dodge durango when they have the same problems as the newer models.
Dt; the ball joints failed at 58,230 miles when the consumer went for the state inspection.
I bought my 1999 Dodge Durango back in may 2003. I had it for almost one year and brought it in for some maintenance. They told me 3 of the 4 ball joints were bad and the fourth one was still within spec, whatever that is. I was also told that one ball joint was about to come apart if I had waited any longer. I had them replaced at a cost of $716. I then continuewd to keep up on the maintenance of them by greasing them regularly and inspecting them once a month. Last month I noticed that the fourth on ethat was not replaced is woren and needs to be replaced. I also see that a recall was done but does not cover all the vehicles that have this problem. I believe that Dodge needs to step up and fix this problem for all the Durangos not just a few.
1999 Dodge Durango began to shake when brakes are applied. Have been to the local Dodge dealer. They have notified me that the problem is due to worn upper ball joints. These ball joints are part of a recall for 2000-2004 Dodge Durangos. I have contacted Chrysler to ask for assistance in replacing the upper ball joints due to the problem that I have experienced. They have denied my request. They have agreed that the upper ball joints used in the 1999 4-wheel drive Durangos is the same at the upper ball joints used in the 2000-2004 Durangos.
Constituent in support of extending the 2000 Dodge dakota recall to include the 1999 model year dakota's as well.
Dodge Durango 4x4 1999 consumer wants to know why not expand recall for the ball joints. While driving, the consumer experienced a funny shake with the vehicle. The mechanic informed the consumer the ball joints and tie rods needed to be replaced.
I've been noticing improper tire wear on my 1999 Durango and had it looked at and was told the ball joints are failing. Now I need to have them repaired at my own expense when the same problem for 2000 to 2003 was addressed by a recall that should have included 1999!!.