Brake Abs Warning Light Problems of Ford Crown Victoria

Ford Crown Victoria owners have reported 3 problems related to brake abs warning light (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Crown Victoria based on all problems reported for the Crown Victoria.

1 Brake Abs Warning Light problem of the 2007 Ford Crown Victoria

Failure Date: 11/07/2011

The contact owns a 2007 Ford Crown Victoria. The contact stated that while driving up an incline at approximately 30 mph, the brake and the abs lights illuminated. The contact also stated that the vehicle began to experience an increased stopping distance after the lights illuminated. The vehicle was taken to a local repair shop, who performed a diagnostic test that was unable to locate a failure code. The manufacturer was notified of the failure. The vehicle was not repaired. The failure mileage was 90,000 and the current mileage was 90,700.

See all problems of the 2007 Ford Crown Victoria 🔎.

2 Brake Abs Warning Light problem of the 1996 Ford Crown Victoria

Failure Date: 09/27/1999

Officer was traveling northbound on summit Ave e at approximately 30-35mph. At the intersection of summit and e. Harrison st, the officer slowed to clear the intersection and to negotiate her patrol vehicle around a traffic circle. The officer negotiated her vehicle around the circle. North of the intersection, the officer attempted to brake, but the brakes did not respond - abs light was on and the abs mode did not function. The officer then attempted to straighten the vehicle, but found that the steering had failed as well. The vehicle fishtailed. The officer's vehicle was now heading west towards a legally parked vehicle on the west side of summit Ave. E. The officer attempted to steer to the right to straighten out the vehicles movement. The officer found that the steering wheel would not turn like it had been locked. The vehicle had total steering failure. The officer was headed straight towards the parked vehicle, jerked the steering wheel as hard as she could to the right. Her vehicle responded but ended up hitting two parked vehicles on the east side of the street. These vehicles were pushed into two additional vehicles and a motorcyle. The office was treated for neck and back injuries.

See all problems of the 1996 Ford Crown Victoria 🔎.

3 Brake Abs Warning Light problem of the 1996 Ford Crown Victoria

Failure Date: 09/27/1999

Officer was traveling northbound on summit Ave e at approximately 30-35mph. At the intersection of summit and e. Harrison st, the officer slowed to clear the intersection and to negotiate her patrol vehicle around a traffic circle. The officer negotiated her vehicle around the circle. North of the intersection, the officer attempted to brake but the brakes did not respond - abs light was on and the abs mode did not function. The officer then attempted to straighten the vehicle but found that the steering had failed as well. The vehicle fishtailed. The officer's vehicle was now heading west towards a legally parked vehcile on the west side of summit Ave. E. The officer attempted to steer to the right to straighten out the vehicles movement. The officer found that the steering wheel would not turn like it had been locked. The vehicle had total steering failure. The officer was headed straight towards the parked vehicle, jerked the steering wheel as hard as she could to the right. Her vehicle responded but ended up hitting two parked vehicles on the east side of the street. These vehicles were pushed into two additional vehicles and a motorcyle. The office was treated for neck and back injuries.




Safety Ratings of Crown Victoria Cars
Fuel Economy of Crown Victoria Vehicles
Crown Victoria Service Bulletins
Crown Victoria Safety Recalls
Crown Victoria Defect Investigations