Ford Crown Victoria owners have reported 4 problems related to brake pedal and linkage (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Crown Victoria based on all problems reported for the Crown Victoria.
While making a turn the 2005 Crown Victoria suddenly accelerated, even though the driver had his foot on the brake. There is a possibility the brake and accelerator pedals are too close together, allowing the driver to apply both pedals at once.
See
all problems of the 2005 Ford Crown Victoria
🔎.
During normal braking, on 2 separate occasions, my father and I both experienced unintended acceleration while braking. This was caused by the fact that the accelerator pedal on our rented Ford Crown Victoria is too close to, and at the same level as, the brake pedal, causing both pedals to easily be pressed at the same time. Excessive force on the brake pedal was the only action possible to prevent accidents in both cases.
Brake pedal going to the floor due to failure of the stop switch and clip on pedal.
See
all problems of the 1996 Ford Crown Victoria
🔎.
Consumer states of having problems with a vibration on the gas pedal. Dealer was notified. Ts.
See
all problems of the 2003 Ford Crown Victoria
🔎.
| Problem Category | Number of Problems |
|---|---|
| Brake Hoses, Lines/piping, And Fittings problems | |
| Service Brakes problems | |
| Brake Electric Antilock problems | |
| Brake Foundation Components problems | |
| Brakes Failed problems | |
| Brake Disc problems | |
| Brake Disc Pads problems | |
| Brake Pedal And Linkage problems | |
| Brake Light On problems | |
| Brake Abs Warning Light problems |