Brake Electric Antilock Problems of Ford Crown Victoria

Ford Crown Victoria owners have reported 12 problems related to brake electric antilock (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Crown Victoria based on all problems reported for the Crown Victoria.

1 Brake Electric Antilock problem of the 1997 Ford Crown Victoria

Failure Date: 03/15/2002

Abs applied brakes with car in cruise control at 65 mph, than brakes were applied to right front which caused the car to pull to the right, left front brakes were applied which caused the car to pull to the left, also lost brake power where you had to really get on the brakes to get the car to stop like the car had no power brakes at all, car right now sets in the driveway as my wife drives the cars and I feel it is a matter of time before this car is involved in a serious crash and I feel it is to dangerous to allow my family to be in the car.

See all problems of the 1997 Ford Crown Victoria 🔎.

2 Brake Electric Antilock problem of the 2002 Ford Crown Victoria

Failure Date: 10/21/2001

Brakes operate erratically, when applying brakes they are hard to press and pedal does not move.

See all problems of the 2002 Ford Crown Victoria 🔎.

3 Brake Electric Antilock problem of the 2001 Ford Crown Victoria

Failure Date: 04/05/2001

This vehicle rear ended another vehicle. Front left tire left a very noticeable skid mark. Appears abs was not functioning correctly.

See all problems of the 2001 Ford Crown Victoria 🔎.

4 Brake Electric Antilock problem of the 1997 Ford Crown Victoria

Failure Date: 02/17/2001

No summary listed for above vehicle.

5 Brake Electric Antilock problem of the 1996 Ford Crown Victoria

Failure Date: 01/22/2001

This is an ongoing problem with all of our 1995-1997 crown Crown Victorias. No safety defect listed in summary.

See all problems of the 1996 Ford Crown Victoria 🔎.

6 Brake Electric Antilock problem of the 1999 Ford Crown Victoria

Failure Date: 12/10/2000

Continous squealing and grinding brakes 4 attempts to correct, no relief.

See all problems of the 1999 Ford Crown Victoria 🔎.

7 Brake Electric Antilock problem of the 1997 Ford Crown Victoria

Failure Date: 01/20/2000

While going down a slight enbankment, brakes applied and locked up. Vehicle almost hit a tree. Mechanic said it was the abs.

8 Brake Electric Antilock problem of the 1999 Ford Crown Victoria

Failure Date: 01/01/2000

When applying brakes on a damp road vehicle pulls to the left. Manufacturer states that this is a normal condition. Vehicle will be checked by dealership. Please provide any further information.

9 Brake Electric Antilock problem of the 1999 Ford Crown Victoria

Failure Date: 05/02/1999

Brakes went bad, they were rubbing metal to metal and making a winding noise. Also, there was a loud clunking noise because the lower control arm went bad, and they replaced it. When consumer applies brakes vehicle pulls to the left.

10 Brake Electric Antilock problem of the 1996 Ford Crown Victoria

Failure Date: 05/22/1996

This is a police vehicle. During an accident the abs system was inoperative and the brakes locked and may have contributed to the accident. Please describe.

11 Brake Electric Antilock problem of the 1999 Ford Crown Victoria

Experiencing chronic brake fade / low brake pedal / vibration coming off freeway/ dealership service claims to have checked brake system / says this is normal / concerned.

12 Brake Electric Antilock problem of the 1999 Ford Crown Victoria

While driving vehicle 35-40mph in wet weather & applying brakes vehicle would pull to the right. Contacted dealership & was informed by mechanic the pulling problem was not correctable.



Safety Ratings of Crown Victoria Cars
Fuel Economy of Crown Victoria Vehicles
Crown Victoria Service Bulletins
Crown Victoria Safety Recalls
Crown Victoria Defect Investigations