Ford Crown Victoria owners have reported 3 problems related to headlight concealment device (under the exterior lighting category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Crown Victoria based on all problems reported for the Crown Victoria.
97 Ford Crown Victoria plastic headlight assemblies fogged over and became useless and dangerous. . Tried various cleaning agents to no avail. . Had to replace both headlamp assemblies. .
See
all problems of the 1997 Ford Crown Victoria
🔎.
The headlight covers on Ford Crown Victoria's (1999 to present) are of a plastic material that develops a film over time that severely reduces the amount of light that is put out by the headlights.
See
all problems of the 1999 Ford Crown Victoria
🔎.
Moisture was inside the headlight lenses. The vehicle was taken to the dealer during the warranty period for the same problem. The lenses were replaced, but the dealer could not determine how the moisture was getting into the lenses. Recently, the same problem developed. The consumer contacted the dealer and they refused service because the warranty has expired. Scc.
See
all problems of the 1998 Ford Crown Victoria
🔎.
| Problem Category | Number of Problems |
|---|---|
| Headlights problems | |
| Exterior Lighting problems | |
| Headlight Switch problems | |
| Tail Light Switch problems | |
| Turn Signal problems | |
| Brake Light problems | |
| Headlight Concealment Device problems | |
| Turn Signal Flasher Unit problems | |
| High/low Beam Switch problems | |
| Hazard Flashing Warning Light problems |