Steering Linkages Problems of Ford Crown Victoria

Sudden failure of ball joints and steering linkage parts.

See all problems of the 1999 Ford Crown Victoria 🔎.

Two authorized Ford dealers misdiagnosed/failed to diagnose until after Ford's basic bumper to bumper (3/36) warranty expired. Ford motor company told me it was a "dealer problem" and further told me it was covered under the extended warranty but that has a $50 debt. This tie rod issue seems to be a problem with these vehicles.

See all problems of the 1998 Ford Crown Victoria 🔎.

All items listed are design flaws and could cause serious if not fatal injuries to occur. . Turn signals will not stay on if they will hold on at all. Twice repaired. . Steering wheel and column jump and vibrate on bump impact at mid to highway speeds. Car swerves. Have not yet lost control!! rear shocks cannot stabilise rear end. . Windshield has ripple distortion. Has caused vision problems. Both front doors will not stay open. . Both my wife and I have been injured by these doors. . Service dept claims doors are within tolerences. . Not mine!! hope ypu can assist me. Thanks,,paul silberman.

See all problems of the 1997 Ford Crown Victoria 🔎.

Marshall mize Ford 96v135 pitman arm; owner took vehicle in on serveral occasions for insufficient lubrication and recall work was not perfomed, manufacturer did not inidcate if parts were available to honor recall.

See all problems of the 1996 Ford Crown Victoria 🔎.

Pitman arm/ball joint is ready to fall out, replaced pitman arm, police car.

Police cars, found 3 pitman arms defective, replaced all three.

Police vehicle. The steering wheel moves and the car will not move with it, especially in curves.

Police cars experiencing excessive play in pitman arms, found during inspection of 11 cars.

Excessive play in pitman arms found during inspection of vehicle. Please describe details.