Brake Light On Problems of Ford Flex

I recently experienced a brake failure on our 2010 Ford Flex. The right rear brake hose failed due to contact with the tire. This resulted in the brake pedal going to the floor and a significant decrease in braking performance. The brake hose failure was the result of improper routing of the brake line that happened when the caliper was replaced. The issue here is that the brake warning light never activated even after the brake pedal went to the floor several times. I have checked the bulb by putting the car in the run position and found that the brake warning light does illuminate at that time. This happened during normal city driving (no heavy traffic, speeds between 0 and 45 mph, stopping at red lights and slowing for turns).

See all problems of the 2010 Ford Flex 🔎.

Multiple problems with advance trac and electrical system. Occurs every five to six months. Service advance trac indicator comes on along with control issues in rain and snow, brake lights not shutting off, cruise control not operating and ignition system has quit working. Not all of this happen at the same time but the recurring issue is the advance trac system and then another part of the system fails or has problems along with the service advance trac warning.

See all problems of the 2012 Ford Flex 🔎.

The contact owns a 2009 Ford Flex limited. The contact stated that the brake light failed to illuminate when the brakes were applied. The vehicle was taken to the dealer where the dealer confirmed that the auxiliary relay was detached from the vehicle. The manufacturer was contacted but the vehicle was not repaired. The failure mileage was 39,000 and the current mileage was 46,000.

See all problems of the 2009 Ford Flex 🔎.