Honda CR-V owners have reported 1 problem related to trunk lid lock (under the latches/locks/linkage category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Honda CR-V based on all problems reported for the CR-V.
The rear interior well cover is a pull out 17lb plastic table. It has a 'd' ring latch that is held to the table with 6 screws. When you pull up on the 'd' ring latch you get a handle to pull the table up and out. When pulling up on the 'd' ring it pulls a plunger out of a slot is the back of the bulkhead of the frame giving you the appearance that the table is locked down. The problem is that there are nothing else holding the table down on the other three sides. It appears that the side opposite the latch should have a slot or maybe two straps across the rear corners for the table to slide into. Appears Honda overlooked this since they made the lifting 'd' ring also a latch. As designed however the cover is not latched down. Just hope no one turns the Cr-v over and after the air bag saves them have a 17 lb table cut their head off.
See
all problems of the 2005 Honda CR-V
🔎.
| Problem Category | Number of Problems |
|---|---|
| Latches/locks/linkage problems | |
| Door Latch problems | |
| Hood Latch problems | |
| Hatchback/liftgate Lock problems | |
| Doors Lock problems | |
| Tailgate Latch problems | |
| Trunk Lid Lock problems |