Engine problems of the 2007 Jeep Commander

The contact owns a 2007 Jeep Commander. The contact stated that the vehicle failed to start and was towed to the dealer who was unable to diagnose the failure. The manufacturer was contacted who did not offer any assistance and the vehicle was not repaired. The VIN was not available. The failure mileage was 39,000 and current mileage 40,000.

The car suddenly shuts down completely when driving on the highway.

The contact owns a 2007 Jeep Commander. While driving between 20-50 mph, the vehicle loses complete power without warning. When accelerating from a stop, the vehicle is unresponsive. On one occasion, the engine lost power in the middle of the intersection and then lunged forward seconds later. The contact attempted to accelerate, but the vehicle lunged twice before responding. The dealer and manufacturer stated that there were no recalls for this failure. The contact has an appointment to have the vehicle inspected on March 9, 2009. The failure mileage was 40,800.

The contact owns a 2007 Jeep Commander 4x4. While driving 70 mph, the vehicle suddenly spun around out of control. The vehicle then shut off on the side of the road and restarted itself after 15 minutes. There were no warning indicators prior to the failure. The dealer test drove the vehicle and found no failures. The VIN and failure mileage were unknown.

The contact owns a 2007 Jeep Commander. While driving at various speeds, the vehicle loses power and shuts off. When she restarts the vehicle, it runs sluggish and with less power. She is unable to accelerate over 30 mph. The contact called the dealer and they advised her to bring in the vehicle to the service department. The dealer could not duplicate the failure on two separate occasions. Nhtsa campaign id number 08v203000 (power train:automatic transmission:control module (tcm, pcm)) was found for the 2006 Commanders. The mileages were unavailable. Updated 10/03/08 the dealer updated the pcm. Updated 10/06/08.