Jeep Commander owners have reported 164 vehicle speed control related problems since 1996. Table 1 shows the 11 most common vehicle speed control problems. The number one most common problem is related to the vehicle's vehicle speed control (117 problems). The second most common problem is related to the vehicle's cruise control (26 problems). For details of each of the problem category, use the links in the table.
2008 Jeep Commander, 4. 7l, qdii system. Vehicle experiences a sudden an unexpected loss of power and braking action while driving at speed. After loss of power, abs, stability control, brake, check engine light, dash board warning lights illuminate and flash. Read details...
Under heavy rain, the vehicle leaks on the inside to the point of a big puddle in the floor of the driver side while stationary. This has also caused a problem with my cruise control and on-screen nav it now goes on and off displaying the Jeep logo as if the car was just starting up and I am in the Read details...
The contact owns a 2006 Jeep Commander. The contact stated that while driving at various speeds, the vehicle suddenly accelerated independently. The contact also mentioned that the brakes seized and would not immediately release. Read details...
Tl- the contact owns a 2007 Jeep Commander 4x2. The contact stated that while idle with the brake pedal depressed, the engine rpm's rapidly increased and the vehicle jerked forward without warning . In addition, the vehicle failed to accelerate when the accelerator pedal was depressed. Read details...
The contact owns a 2007 Jeep Commander 4x4. The contact stated that while driving at approximately 70 mph, the accelerator pedal was depressed but the vehicle failed to accelerate as the vehicle jerked forward. The failure recurred two times. Read details...