Paint Problems of Mazda MAZDA6

Mazda MAZDA6 owners have reported 4 problems related to paint (under the structure category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Mazda MAZDA6 based on all problems reported for the MAZDA6.

1 Paint problem of the 2020 Mazda MAZDA6

Failure Date: 11/25/2020

Excessive paint chipping. I have the soul red (v46) paint. It was purchased on 06jun2020 and has only 2,000 miles but it has 3 large chips. Most of the miles are just going to the store. I work from home so I don't drive but a couple days a week.

See all problems of the 2020 Mazda MAZDA6 🔎.

2 Paint problem of the 2010 Mazda MAZDA6

Failure Date: 02/13/2020

Paint is chipping away on the rear of the car.

See all problems of the 2010 Mazda MAZDA6 🔎.

3 Paint problem of the 2010 Mazda MAZDA6

Failure Date: 06/01/2018

I'd like to report my observation in regards to the following investigation: pe18006 upon performing routine maintenance I observed heavy corrosion of the subframe of my vehicle heavily concentrated towards the rear ends of said subframe. The damage is largely concentrated on the passenger side of the sub frame but both drive and passenger sides are in varying states of corrosion. I can contribute additional information upon request but I wanted to add to the on-going investigation that heavy corrosion to the point of me questioning the structural integrity of said subframe is for sure an issue I'm experiencing. I have not checked the welds to the various suspension components attached to sub frame but the pinch welds along the interior edge of the sub frame have been compromised allowing the ingress of additional water which I believe is accelerating this issue. The whole lower surface of the sub frame towards the rear of the sub frame has begun corroding as well and the paint covering the sub frame has bubbled up or separated along the edge of the corrosion.

4 Paint problem of the 2003 Mazda MAZDA6

Failure Date: 06/01/2008

The contact owns a 2003 Mazda 6. The contact stated that the paint was blistered on the fender on the rear passenger side of the vehicle. The dealer stated that they were aware of the corrosion on the rear fender. The dealer referred the contact to a body shop for repair; however, he took the vehicle to his body shop instead. The mechanic inspected the fender and pieces of it came off in his hand. The mechanic repaired three holes in the rear passenger side fender. The failure mileage was 80,000 and current mileage was 85,000. Updated 08/23/08. Lj the fender rusted in 3 places. Updated 08/25/08.

See all problems of the 2003 Mazda MAZDA6 🔎.


Other Common Structure related problems of Mazda MAZDA6



Safety Ratings of MAZDA6 Cars
MAZDA6 Service Bulletins
MAZDA6 Safety Recalls
MAZDA6 Defect Investigations