Turn Signal Switch Problems of Mercury Sable

Wiper intermittently coming on by itself. Multi-function switch had to be replaced.

See all problems of the 1999 Mercury Sable 🔎.

Problems with abs. The vehicle was in two accidents due to the inability to control the vehicle during normal driving conditions, where the abs did not work. The vehicle was in for repair 7 times. The following are repairs and or problems the vehicle experienced: torque converter replaced after transmission fluid was found low, exhaust leak fixed, washer fluid would spray when the turn signal and lights were on, shaking when the brakes were applied/resurfaced rotors, trunk leaked water, replaced multi-function switch to fix washer fluid problem, abs not working when there was a panic stop, left and right spindle assembly was replaced, front end rotors were replaced again, wheel alignment, the abs did not engage and caused an accident, and replaced left side outer tie rod end.

When turning a corner signal lights will go out before turn is complete. Please provide any further information.

See all problems of the 2000 Mercury Sable 🔎.

Whenever turning on signal light to make a turn signal will stop before actually make the turn. Please provide any further information.

When putting on turn signal and starting to turn, turn signal light will go off before turn is complete. Delaer stated the multifunction switch was faulty, also the driver seat belt does not retract properly.

The left directional switch does not stay on.

Vehicle started to act sluggish, engine check light came on. Vehicle was not operating properly. Took to dealer who said that it was a multi-function relay switch that caused air pump not function properly.

See all problems of the 1996 Mercury Sable 🔎.

While making a left turn with turn signal and windshield wipers on, windshield wiper fluid would automatically come out. Visiblity would be very difficult since the fluid came out unexpectedly, and consumer could get into an accident.