Steering Rack And Pinion Problems of Nissan Quest

Nissan Quest owners have reported 2 problems related to steering rack and pinion (under the steering category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Nissan Quest based on all problems reported for the Quest.

1 Steering Rack And Pinion problem of the 2006 Nissan Quest

Failure Date: 06/01/2007

My Quest was purchased 12/06. Since then the odometer has malfunctioned. They would not fix it. The brake disc have malfunctioned twice, even after Nissan replaced them. The response from Nissan was "hotspots happen normally in discbrakes". The motor mounts went bad after 2. 5 years. Now I am faced, after a little more than 4 years with "power steering pump" replacement and "rack and pinion assembly.

See all problems of the 2006 Nissan Quest 🔎.

2 Steering Rack And Pinion problem of the 1997 Nissan Quest

Failure Date: 07/20/1997

The vehicle has been plagued with a reoccurring intermittent "rubbing" sound when turning the steering wheel. Nissan has characterized the problem as "excessive friction" and "internal failure". To date, they have replaced the rack & pinion steering gear assembly, and associated parts 3 times, 8/97, 7/98 and 1/99. With the last replacement we were told that the rack & pinion being installed was a redesigned one. However, the noise has returned just under a year (10,000 miles) from the last replacement. We are currently attempting to get both the dealership and the manufacturer to address this reoccurring problem again.

See all problems of the 1997 Nissan Quest 🔎.




Safety Ratings of Quest Cars
Fuel Economy of Quest Vehicles
Quest Service Bulletins
Quest Safety Recalls
Quest Defect Investigations