Two problems related to brake master cylinder have been reported for the 2007 Toyota Camry. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2007 Toyota Camry based on all problems reported for the 2007 Camry.
This all started December 16, 2013, when I lost power while driving and my car broke down on the road. I had the master cylinder, alternator, battery, and air mass flow sensor replaced. Picked the car up drove it home and she still felt a little sluggish but I figured the car was cold. Went to have it inspected the next day and my brakes were locked! had it towed back to the shop and he replaced the master cylinder again. Pickedt it up drove it home and the car started shaking at 60 mph again I figured it was cold and made it home. Next day drove it to work, the car went to 50, 40, and then 30 mph and would not go faster than that! I had it towed back to the shop and my mechanic did some research and it appears this is a known issue with 2006 and 2007 models. It starts with the braked cylinder and as long as the brakes don’t get hot it runs fine. Once they get hot the brakes applies itself which forces your car to slow down! this is so dangerous! you basically have to replace you entire brake line and or check all the hoses, brake booster ext. Until you can pinpoint the problem. Is Toyota doing a recall on this?.
: my Toyota 2007 subject : brake master cylinder make / model years : Camry you have listed the 2004-2006 models but I took my 2007 to the conyers, georgia, dealership for maintenance and this is the exact same defect they wanted me to pay for. I didn't have the money so they told me to just keep the brake fluid full. I need you to cover this replacement charges for my brake master cylinder. Their finding is also documented in the computer for that repair assessment, at the shop for that maintenance visit. I also was given a copy.