Three problems related to horn assembly have been reported for the 2010 Toyota Corolla. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2010 Toyota Corolla based on all problems reported for the 2010 Corolla.
Tl takata recall. The contact owns a 2010 Toyota Corolla. The contact stated that the horn began to fail after the vehicle was repaired per NHTSA campaign number: 16v340000 (air bags) by Toyota of pharr (1625 w expy 83, pharr, TX 78577, 1-800-347-2360). In addition, the air bag warning indicator remained illuminated after the repair. The contact was uncertain if the part that was replaced caused the failure or if the remedy was the cause. The dealer indicated that a service appointment needed to be scheduled for the horn failure. The vehicle was not repaired. The manufacturer was notified. The failure mileage was not available.
Takata recall for almost eight months my car horn has not been working. I cannot inspect it without the car horn working! no one will touch it! it's like my car has a disease and no one wants to be corrupted or something. I saw on a tv program called fraud squad about how when a airbag is deployed some components in and around the airbag are affected to the point of failure. I've only had the car two years and the most important thing, the inspection/registration sticker cannot be had! I feel very much let down by the dealership I acquired this car from. I got it from fort bend Toyota in rosenberg. It's gonna take me many years to pay this car paid off and already I may have to jury rig it and void every warranty ever. My warranty went out, they asked me to re-up it, I didn't, and boom, I'm screwed! where can I go to get help with this? I am lucky I have not been ticketed yet.
Horn failed to honk when needed. It did not work while vehicle was in motion on a highway, it did not work on a city street, it did not work parked in my driveway. The wire became separated and there was a void, the wire cover stayed intact until I removed the connector from the horn. I had to connect a new wire from the existing wire and reconnect to the horn. All is fine now.