One problem related to brake antilock wheel speed sensor has been reported for the 2005 Toyota Sequoia. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2005 Toyota Sequoia based on all problems reported for the 2005 Sequoia.
The contact owns a 2005 Toyota Sequoia. The contact stated that when the brakes were engaged at an unknown speed, the pedal went to the floor as the abs and traction control warning indicators illuminated. The vehicle was able to be pulled over and stopped. The vehicle was taken to the dealer where it diagnosed that the abs hydraulic assembly, wheel speed sensor, stroke sensor, and engine control system had failed and needed to be replaced. The vehicle was repaired however; the brake failure continued to recur. The vehicle was taken back to the dealer where it was diagnosed that the vehicles actuator had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 133,000.