Electrical Jack Problems of Toyota Sequoia

Toyota Sequoia owners have reported 2 problems related to electrical jack (under the equipment category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Toyota Sequoia based on all problems reported for the Sequoia.

1 Electrical Jack problem of the 2002 Toyota Sequoia

Failure Date: 10/02/2006

During 2006, the rear liftgate window frame rusted causing the rear window to fall open. The dealer stated it would cost ~$1,600 to replace the equipment and associated parts. I decided not to replace due to the infrequent usage of the rear liftgate window. Around March 15, 2015, the rear window fell open due to complete destruction of the window frame and associated hardware due to corrosion. Also, in February 2015, noticed that the frame of the vehicle was "soft" while jacking the vehicle for brake inspection. The vehicle has the same frame as the Toyota tacoma which was recalled by Toyota many years ago due to excessive corrosion issues. My vehicle is exhibiting the same problem.

See all problems of the 2002 Toyota Sequoia 🔎.

2 Electrical Jack problem of the 2002 Toyota Sequoia

Failure Date: 03/13/2006

: the contact stated recalled work was not performed in what the contact considers a timely matter. The dealer was contacted about the recall; however could not work the vehicle into the schedule for 2 weeks. The recall notice received was NHTSA # 05v225000, concerning the lower ball joints. Additionally, the contact was jacking up the vehicle and the housing around the jack fractured and broke. The dealer was contacted and suggested replacing the jack.




Safety Ratings of Sequoia Cars
Fuel Economy of Sequoia Vehicles
Sequoia Service Bulletins
Sequoia Safety Recalls
Sequoia Defect Investigations