Ignition Module problems of the 1996 Chevrolet Blazer

Three problems related to ignition module have been reported for the 1996 Chevrolet Blazer. The most recently reported issues are listed below.

1 Ignition Module problem

Failure Date: 07/01/2000

Anti-lock brake warning indicator light came on . Took to rothrock Chevrolet, springfield , PA. They stated that the ecm module needed to be replaced and stated that it would cost in excess of $1,000. 00. No problems prior . Is this related to the recent recall regarding the anti-lock system computer possibly?.

2 Ignition Module problem

Failure Date: 06/01/1997

Recall 99i006000 was repaired by the dealership. However, after defect was repaired brake system will lock up, and consumer will lose control of steering. Vehicle stalled 2 times after driven, then shut off for 15 minutes then restarted, dealer reprogrammed ecm. Front brake pads replaced, resurfaced rotors, replaced worn out brakes, during light braking during light rain, abs kicks in. Rear tires worn on outside edges, consumer did not give any specific information regarding tires.

3 Ignition Module problem

Computer chip in engine failed.




Safety Ratings of Blazer Cars
Fuel Economy of Blazer Vehicles
Blazer Service Bulletins
Blazer Safety Recalls
Blazer Defect Investigations