Chevrolet Blazer owners have reported 9 problems related to exterior rearview mirror (under the visibility category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chevrolet Blazer based on all problems reported for the Blazer.
- the contact's vehicle caught on fire while parked. She stated that this was the second time that she has had a fire in the truck. The contact stated that itwas the driver's side mirror motor that caught on fire again. She will have a police and fire report to state the cause of the fire.
See
all problems of the 1997 Chevrolet Blazer
🔎.
Consumer stated that due to the outside rearview mirror being electric it would be hard to move or not move at all. Dealer notified.
See
all problems of the 2002 Chevrolet Blazer
🔎.
Exterior rearview mirror failed.
See
all problems of the 1998 Chevrolet Blazer
🔎.
The design of driver's left mirror causes mirror to vibrate, resulting in poor visibility.
Outside rear view mirror failed.
See
all problems of the 1996 Chevrolet Blazer
🔎.
The passenger's side outside mirror is too curved, and the car looks further back when actually the car is much closer than it appears. The sign on the mirror says that the objects are closer than they appear, but they really are much closer.
Power memory outside mirrors move on their own to positions outside driver's field of vision. Mirrors tilt down in reverse but fail to return to previous position when vehicle is taken out of reverse. Dealer contacted technical assistance at general motors who suggested to rebuild body control module -- did not correct problem. Technical assistance reports 4 similar defects with the same vehicle and states may be problem with the amount of memory alloted to mirrors. Tan case #5205486. Thus far, a solution is reported unavailable.
The right side outside mirror cannot be properly adjusted to eliminate a blind spot. It locks in to a "normal" driving position and even the power adjustment cannot move the mirror far enought out. The preset mounted angle is wrong. I called the service manager and he told me I am not the first to complain and even he, when he was using a Blazer noted that the mirror would not take a proper setting. He told me he even "called around" and was told that's the way it's comes from the factory and cannot be changed. It must be corrected so the blind spot on the right side is eliminated.
See
all problems of the 2000 Chevrolet Blazer
🔎.
Excessive glare off drivers side mirror from head lamp switch at night time driving, need to have something mounted on side of switch to remove glare off side mirror.
See
all problems of the 2001 Chevrolet Blazer
🔎.
| Problem Category | Number of Problems |
|---|---|
| Windshield Wiper/washer Motor problems | |
| Windshield Wiper/washer problems | |
| Windshield Wiper/washer Switch problems | |
| Rear Window Wiper Washer Motor problems | |
| Defogger problems | |
| Wiper problems | |
| Defogger Heater problems | |
| Windshield problems | |
| Side/rear Glass problems | |
| Exterior Rearview Mirror problems |