Front Suspension Hub Problems of Chevrolet Blazer

Had a terribly loud noise in the front end of our 2001 chevy Blazer and found out it was a front wheel hub and bearing assembly, cost $439. 81. Now one year later the other side has gone and had to be replaced, we have almost $900. Into this repair that I now see appears to be a frequent problem with this vehicle. General motors needs to be accountable for there products, either on there own or forced to do some type of recall. We also had to have the brake light recall taken care of.

See all problems of the 2001 Chevrolet Blazer 🔎.

Front wheel hubs wearing out at 40,000 miles, resulting in loss of vehicle use and 1,000 dollar repair bill after several complaints about the front end to the dealer before warranty ran out.

See all problems of the 2002 Chevrolet Blazer 🔎.

Both front wheel hub assembly failed at the same time.

Groaning noise coming from right front of vehicle. Diagnosed by dealer as right front wheel bearing/hub assembly failure. Right front wheel hub assembly replaced.

See all problems of the 1999 Chevrolet Blazer 🔎.

There was roaring noise in the front end when consumer accelerated. Dealership indicated that the noise was due to the bearings. Hub and the bearing assembly were replaced.

See all problems of the 2000 Chevrolet Blazer 🔎.

In less than 4 years I have had 2 major car repairs on my Blazer. On trip to the chevy dealer they replaced the following: hift solinoid right front hub brg dry/grouwling, brg failed replaced hub brg assmy. My truck had 54,515 miles. The stone mountain Chevrolet dearlership in stone mountain GA did the repair. The next large repair is for a rear differential overhaul. The technician said that this is caused by major towing but ther is no hich on the truck and there is 99,000 miles on the truck.