Chevrolet Camaro owners have reported 2 problems related to brake light on (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chevrolet Camaro based on all problems reported for the Camaro.
The high mount led brake light is mounted on the rear windshield at an angle that receives direct heat from the sun causing a slim crack on the brake led board. The crack will shift back and forth sometimes illuminating when braking but at times the slim crack on the led board will prevent the lamp from illuminating causing an immediate safety hazard to passengers of insufficient brake notification to traffic following behind. A replacement led lamp will suffer the same fate based on the angle of the lamp positioned facing the direct heat of the sun. I was in motion and pulled over by le because the lamp was out but worked intermittently while the officer and I tested it. Mechanics inspected the lamp and found the slim crack on the led board that allowed shifting of contacts. Dealerships have reported this slim crack on the led board as a common problem due to the intense heat of the sun bearing down on the led lamp which is angled out with no visor.
See
all problems of the 2013 Chevrolet Camaro
🔎.
When pressingdown on brake pedal it goes to the floor. Has to pump brakes to stop vehicle. Also, brake light comes on. This only happens when coming to a stop.
See
all problems of the 1996 Chevrolet Camaro
🔎.