Two problems related to engine clicking and tapping noises have been reported for the 2016 Chrysler 200. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2016 Chrysler 200 based on all problems reported for the 2016 200.
Tl the contact owns a 2016 Chrysler 200. While driving 30 mph, the vehicle stalled, but was able to restart after three attempts. There were no warning indicators illuminated; however, "place vehicle in park" was displayed. The vehicle was towed to richardson Chrysler Jeep Dodge ram (1321 n central expy, richardson, TX 75080, (214) 329-0862) where it was diagnosed that the engine needed to be replaced. The vehicle was repaired, but the failure recurred. Additionally, while driving at unknown speeds, there was an abnormal popping noise and the vehicle stalled. All of the warning indicators on the instrument panel illuminated. The vehicle was towed back to the dealer where it was diagnosed that the transmission needed to be replaced. The vehicle was not repaired. The failure mileage was 35,550.
The pressure on my front drivers side isnt reading it at all at first I thought it was a an electrical so I changed it then a popping and clicking sound started so I went to a mechanic and they told me it was the cv axel joint I replaced it still persist they said it might be a valve ok I replaced still has the popping and clicking sound and to top it off when im pushing on the gas pedal to go faster the car for some reason pulls back they told me at the Chrysler auto repaid it might be because it needs the transmission oil change I made an appointment and had it done but it still persists I don't know what else to do its cost me so much money to try to figure out what wrong with it and for some one on minimum wage its getting very difficult to continue paying this vehicle that has problems that just won't go away.