Engine Clicking And Tapping Noises Problems of Chrysler 200

Tl-the contact owns a 2012 Chrysler 200. While driving 35 mph the steering wheel failed to move and vehicle stalled however . Restarted after five minutes. While making a left turn the vehicle stalled again . While attempting to start vehicle there was abnormal ticking noise detected. The abs and traction control warning lights were illuminated. Additionally, the speedometer was inoperable. The local dealer was not contacted. The manufacturer was contacted but no further assistance was provided. The failure mileage was 114,000. Ap.

See all problems of the 2012 Chrysler 200 🔎.

Tl the contact owns a 2016 Chrysler 200. While driving 30 mph, the vehicle stalled, but was able to restart after three attempts. There were no warning indicators illuminated; however, "place vehicle in park" was displayed. The vehicle was towed to richardson Chrysler Jeep Dodge ram (1321 n central expy, richardson, TX 75080, (214) 329-0862) where it was diagnosed that the engine needed to be replaced. The vehicle was repaired, but the failure recurred. Additionally, while driving at unknown speeds, there was an abnormal popping noise and the vehicle stalled. All of the warning indicators on the instrument panel illuminated. The vehicle was towed back to the dealer where it was diagnosed that the transmission needed to be replaced. The vehicle was not repaired. The failure mileage was 35,550.

See all problems of the 2016 Chrysler 200 🔎.

The pressure on my front drivers side isnt reading it at all at first I thought it was a an electrical so I changed it then a popping and clicking sound started so I went to a mechanic and they told me it was the cv axel joint I replaced it still persist they said it might be a valve ok I replaced still has the popping and clicking sound and to top it off when im pushing on the gas pedal to go faster the car for some reason pulls back they told me at the Chrysler auto repaid it might be because it needs the transmission oil change I made an appointment and had it done but it still persists I don't know what else to do its cost me so much money to try to figure out what wrong with it and for some one on minimum wage its getting very difficult to continue paying this vehicle that has problems that just won't go away.

On December 2015, I bought the 2015 Chrysler 200 limited from gilroy Chrysler dealer. (malfunction #1) on Sunday April 17, 2015, @ approximately 9:45 I drove my Chrysler less than a mile from my home when I made a right turn & my car turned off and the steering wheel locked up. I started my vehicle and was able to drive it. (malfunction #2) the vehicle has also had problems making a clicking noise when going in reverse like metal on metal contact. (malfunction #3) when I put the vehicle in drive it is delayed and changes hard. On April 23, 2015 my vehicle was serviced for an oil change & tire rotation @ (stevens creek Jeep Dodge) 4100 stevens creek blvd, CA 95129 and the service advisor was advised. He advised they were booked up for 3 weeks in order to conduct a diagnostic check under the vehicle's warranty. The vehicle was serviced and it is scheduled for the first week of may. The dealer would not give a for a temporary vehicle until the vehicle is safe to drive. I am a single mother two children.

See all problems of the 2015 Chrysler 200 🔎.

Tl-the contact owns a 2015 Chrysler 200. The contact stated that while driving at unknown speeds there was an abnormal clunking noise. Additionally, when the push to start button was pressed the vehicle failed to start. The gear shifter was hard to shift into gear. The air bag warning light was illuminated. The vehicle was taken to the local dealer premier Chrysler Jeep Dodge 13000 I 10 service rd new orleans la 70128 888-358-9233 where diagnosed that the system needed to be reset. The bolts needed to be tighten the vehicle was repaired however the failures recurred. The manufacturer was notified of the issue but no further assistance was provided. The failure mileage was 38,193. Ap.

I was stopped at stop sign when I took foot off brake pedal to accelerate it couldn't get traction with back tiers it felt like the back right tire locked up and it jerked back and forth until I took foot off accelerator. I stopped but couldn't see anything wrong. This happened on 8-28-15. On 8-29-15 was in a drive thru and when car is in park and I put in drive it makes a clicking sound from engine and car jerks somewhat with my foot on the brake. I have noticed that when I accelerate it hesitates to go. I am very concerned about this problem because I am almost scared to drive it because of the hesitation to go, and could cause a wreck if the tire thing happens again.

I purchased a used Chrysler 200 touring 2014, on 2/24/2015. The year make of the vehical is 2014 on the inside sticker, but the model # of the engine is 2013. The vehical was parked in the garage as, I turned the key to start the car the car engine began to make a knock, clunking sound and it hesitated to start. The engine sounded like it was about to break, or engine damage had occured. This happened on two occations within 6 months. In more than 5 occations driving on the freeway to speed up, or to change lanes the vechical accelerating is stuck and keeps acceleratimg in an upward rhythem. In addition, there is no control of the gas pedal during time the vehical is accelerating. I brought the car in to be checked at Honda where I purchased the vehical, Honda this day had the Chrysler dealership do a diagnostic test on my Chrysler touring 200, 2013 model. I was told that nothing was found wrong with the vehical, and no additional service needed. I have been doing research with safecar. Gov reading all the complaints and recalls for the Chrysler 200 touring 2013. I am shocked that they had not been more courteous, or helpful about the potential risk, and problems descriptions of the Chrysler touring 200 2013. I was turned away just like all the other customers, but what if my car stalls on the freeway, than what? my car is a potential danger and I cannot afford to buy another car. I fear I will be a victum of the "lemon law. ".

See all problems of the 2013 Chrysler 200 🔎.

I was driving and all of a sudden I came to a red light and the engine went to shaking really bad and it cut off then the engine light came on it blinked a couple of time so I went to park it the next morning had it put on a machine it read cylinder 2 misfire so I took it to Chrysler dealership where they told me it just needed an software update which I clearly explained what the machine was reading from the code from the engine light now the car completely shut off and didn't not crank up keep trying heard a popping noise like something got caught in the fan and gasoline was spilling from the rear of the car 13 Chrysler 200.

Brakes rotors bushings engine has whine and what sounds like a miss clicking noise on start up, clicking when turning ignition key withoht starting completely, and clicks when turning key off. Salesman says he called Chrysler and was told the 200 car is made to veer to the right to stop driver who might accidentally go to sleep from entering oncoming traffic. Dealership said call warranty. Had this 2012 car a with 46k that was a rental for a few days so far its engine is quite noisy. Calling warranty company to make appt to have car checked out.

Purchased vehicle on Nov. 1st. 2013. Noticed when turning off vehicle there is a loud clicking sound on front right of vehicle. Had it checked by a mechanic and was informed that there was a sensor malfunction near the timing cover. Went to dealership and was told that this was normal for this model and make of vehicle. Someone is wrong,either the mechanic or the dealership. Who?.