Engine Grinding Noise Problems of Chrysler 200

Chrysler 200 owners have reported 3 problems related to engine grinding noise (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chrysler 200 based on all problems reported for the 200.

1 Engine Grinding Noise problem of the 2016 Chrysler 200

Failure Date: 08/24/2020

Tl- the contact's husband owns a 2016 Chrysler 200. The contact stated that while her daughter was driving at various speeds, an abnormal, grinding noise would emit upon depressing the brake pedal without warning. The contact took the vehicle to an independent mechanic where they found no defects with the vehicle. Soon after the inspection, the contact then stated that her daughter had informed her that the oil and the transmission warning lights have appeared on the instrument panel. The contact had called ferman Chrysler Jeep Dodge ram � wesley chapel(24314 FL-54, lutz, FL 33559) where they were informed that a service manager would call them back,, the contact had yet to hear back from the dealer. The manufacturer had yet to be notified of the failure. The vehicle had yet to repaired. The failure mileage was approximately 21,000. Jo.

See all problems of the 2016 Chrysler 200 🔎.

2 Engine Grinding Noise problem of the 2015 Chrysler 200

Failure Date: 03/08/2018

On Thursday 03/8/2018 and Saturday 03/10/2018 we started our vehicle without incident and traveled less than 1/4 of a mile down our street when a warning alarm sounded and the dash board read something like, "pull over and place vehicle in park in order to start. " when we tried to start (key-less car) it would not start right way and made an almost grinding sound. After about 30 seconds to a minute, eventually it started. I do see 2 recalls for this vehicle which describe the vehicle stalling without warning but when I place my VIN in the search it does not identify any recalls on this vehicle. The recall numbers I believe may relevant to our vehicle is Chrysler's r24 and s55.

See all problems of the 2015 Chrysler 200 🔎.

3 Engine Grinding Noise problem of the 2011 Chrysler 200

Failure Date: 10/01/2011

When shifting into reverse or drive it has a hard jolt when going into gear. Sometimes it is so hard that it jerks your body and head/neck, and it sounds like the transmission is going to unbolt from under the car. It does it a couple times a day, and then may stop for a few days but always comes back. I have noticed on the days it is not doing it I average more mpg, and when it is doing it the mpg continuously decreases when it is occuring multiple days in a row. On the days that it is doing it my transmission sounds more whiny than than usual. I have also had issues when putting it into gear, and pushing the gas pedal it tries to stall. It is a problem, and not "just the way those motors are". If it was "just the way the motor" is then it would do it every time you put it in gear, and not come and go and be much worse on some days than others. As time passes the jolting is getting worse and harder. Also, my brakes make an awful squeeking/grinding noise when stopping slowly (stop sign) or backing up. When the car was checked I was told they could not find anything wrong with the car or brakes. This is very agrivating because it was bought brand new, and I am having these issues. I am making payments on a vehicle that is having these types of issues, and I do not feel safe in it. The way the transmissions acts I am afraid of what it may do while driving down the road.

See all problems of the 2011 Chrysler 200 🔎.




Safety Ratings of 200 Cars
Fuel Economy of 200 Vehicles
200 Service Bulletins
200 Safety Recalls
200 Defect Investigations