Fail To Accelerate Problems of Chrysler 200

Chrysler 200 owners have reported 5 problems related to fail to accelerate (under the vehicle speed control category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chrysler 200 based on all problems reported for the 200.

1 Fail To Accelerate problem of the 2015 Chrysler 200

Failure Date: 11/23/2016

The contact owns a 2015 Chrysler 200. While driving approximately 40 mph, a loud abnormal noise was heard from the front of the vehicle. The vehicle began to lose power and then stalled. The contact turned the engine of and was able to restart the vehicle. In addition, while depressing the accelerator pedal to the floorboard, the vehicle failed to accelerate. The contact noticed that the front passenger side tire was leaning outwards. The vehicle was towed to a dealer where it was diagnosed that the axle had detached and needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The approximate failure mileage was 55,000.

See all problems of the 2015 Chrysler 200 🔎.

2 Fail To Accelerate problem of the 2016 Chrysler 200

Failure Date: 05/04/2016

A few times pulling out into the traffic the car would fail to accelerate properly almost causing an accident. Also, some times while driving the car seems as if its dying or loosing power. It is also rattling when I crank it up. The other thing is that the transmission while accelerating seems to take a while to switch gears and then the car jerks really hard when it finally shift gears. I've taken it in to the dealership and they just said that they checked it and cant find anything wrong but that they have had similar complaints but that "its just the fact that the car is a 4 cylinder. " it's very scary pulling out into traffic.

See all problems of the 2016 Chrysler 200 🔎.

3 Fail To Accelerate problem of the 2012 Chrysler 200

Failure Date: 06/02/2015

The contact owns a 2012 Chrysler 200. The contact stated that the transmission failed to shift gear without warning. The contact mentioned that sometimes the shift lever would become stuck to the first gear and the vehicle failed to accelerate over 30 mph. The vehicle was taken to a dealer. The technician diagnosed that the power control module and valve body were defective and needed to be replaced. The vehicle was repaired but the failure recurred. The manufacturer was notified of the failure. The failure mileage was 13,500.

See all problems of the 2012 Chrysler 200 🔎.

4 Fail To Accelerate problem of the 2015 Chrysler 200

Failure Date: 10/31/2014

Tl-the contact owns a 2015 Chrysler 200. The contact stated that while driving that various speeds, the vehicle jerked and the accelerator pedal was depressed but the vehicle failed to accelerate. The failure recurred numerous times. The vehicle was taken to a dealer or diagnosed. The vehicle was included in NHTSA campaign number: 15v47000 (electrical system). The manufacturer was made aware of the failure. The failure mileage was approximately 200. Sg.

5 Fail To Accelerate problem of the 2012 Chrysler 200

Failure Date: 09/09/2014

The contact owns a 2012 Chrysler 200. When the accelerator pedal was depressed, the vehicle failed to accelerate. In addition, the vehicle hesitated and stalled without warning. The vehicle was able to be restarted, but the failure recurred. The dealer was unable to diagnose the cause of the failure. The manufacturer was not notified. The approximate failure mileage was 67,000.




Safety Ratings of 200 Cars
Fuel Economy of 200 Vehicles
200 Service Bulletins
200 Safety Recalls
200 Defect Investigations