Chrysler Sebring owners have reported 5 problems related to brake pedal and linkage (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chrysler Sebring based on all problems reported for the Sebring.
The contact owns a 2004 Chrysler Sebring sedan. While driving at an unknown speed, the front driver side tire separated from the ball joint. In addition, the vehicle collapsed and the brake pedal traveled to the floorboard. The vehicle was towed to the contact's residence. The vehicle was not diagnosed or repaired. The VIN was not included in NHTSA campaign number: 10e059000 (suspension). The manufacturer was not notified of the failure. The approximate failure mileage was 240,000.
See
all problems of the 2004 Chrysler Sebring
🔎.
The contact owns a 2007 Chrysler Sebring. While driving less than 10 mph and approaching a stop, the contact depressed the brake pedal to allow a pedestrian to cross. The vehicle continued to accelerate and she could hear the engine revving. The vehicle stopped, but hesitated as if it wanted to proceed forward. The incident occurred at least six times. The failure mileage was 20,500 and current mileage was 21,000. Updated 10/16/08
the consumer stated the brake and accelerator pedal were designed too close together. Updated 10/20/08.
See
all problems of the 2007 Chrysler Sebring
🔎.
The distance between the gas and brake pedals is designed poorly. When transferring foot from one pedal to another it will get stuck between the pedals.
See
all problems of the 1996 Chrysler Sebring
🔎.
Nar 9-10-03. Gas pedal stuck to the floor while the vehicle was accelerating very fast. The vehicle would not stop until the consumer could apply the emergency brake.
See
all problems of the 1997 Chrysler Sebring
🔎.
Brake pedal and accelarator are design to close, resultin in hitting the gas pedal when hitting the brakes.
See
all problems of the 2001 Chrysler Sebring
🔎.