Abs Brake Fail Problems of Dodge Grand Caravan

Received "safety recall l01" to replace the occupant restraint controller module (orc). The l01 recall was performed at Dodge dealership in daytona auto mall, daytona beach florida where the vehicle was originally purchased. According to the procedure to replace the orc, the electronic stability dynamic sensor (esp) had to be removed and re-installed as part of the replacement for the orc. Vehicle was picked up and driven home that day. The next day the vehicle was started and the esp, bake assist sensor (bas), and traction control sensor lights appeared on the dash. Returned vehicle to Dodge dealer to verify that this was not caused by the recall procedure. Dodge dealer checked abs codes and said the steering angle control /clock spring sensor was defective, and would cost $500 plus to fix. All these components are connected to the abs system. I just cannot believe that one day after the l01 recall was done, that another component of the abs system failed.

See all problems of the 2008 Dodge Grand Caravan 🔎.

Tl-the contact owns a 1993 Dodge Grand Caravan. The contact stated the abs brake fail. While trying to stop the vehicle and depress the brake the vehicle would not stop. The dealer was taken to the dealer who stated they cannot repair the vehicle and offered no other assistance. The manufacturer was notified who stated there was a recall NHTSA campaign id number: 96v099000: service brakes, hydraulic: antilock. But his VIN was not included. The manufacturer offered no other assistance on the failure. The vehicle was not repaired. The failure mileage was 105,000. Mw.

Front brake failure excessive wear brake pads- about two weeks from acceptable pads to nothing metal on metal caused by hub bearing failure - allows the wheel to move horizontally on the axle shaft. There was no indication of bearing failure prior to brake pad wear failure of the hub bearings could be the reason for many of the brake pad wear problems on these vehicles had to replace the rear bearing hubs 6 months after purchasing the vehicle in 2005- replaced left and right front bearing hub assemblies, rotors, and brake pads also abs failure - sensors are controlled by the computer module which is prone to failure - controls all the electrical systems of the vehicle. So replacing individual wheel sensors does not fix the problem - only replacing the faulty computer control module will eliminate the problem until it fails again.

See all problems of the 2005 Dodge Grand Caravan 🔎.

Vehicle experienced abs failure caused by the rotors delaminating.

See all problems of the 2002 Dodge Grand Caravan 🔎.

Abs brake failure, when brakes were applied, experienced exteneded stopping distance, also the pedal was very soft.

See all problems of the 1996 Dodge Grand Caravan 🔎.

Abs system failed.

Abs brakes failed caused collision, pedal went back and brake driver's foot. Yh.

See all problems of the 1999 Dodge Grand Caravan 🔎.