Brake Pedal And Linkage Problems of Dodge Ram 2500

The contact owns a 2014 Dodge Ram 2500. While driving at various speeds with the cruise control activated, the vehicle accelerated independently when the brake pedal was depressed to deactivate the cruise control. The vehicle was taken to the dealer, who diagnosed that the brake pedal switch needed to be replaced. The vehicle was repaired. In addition, the contact stated that a load noise was present coming from the front end of the vehicle. The vehicle was taken to the dealer, who diagnosed that the track arm assembly needed to be replaced. The vehicle was repaired but the failure persisted. The manufacturer was notified of the failures. The failure mileage was 18,000.

See all problems of the 2014 Dodge Ram 2500 🔎.

I purchased a 2005 Dodge Ram 2500 3 months ago and only have 10,000 miles on the truck. On Friday, November 11, 2005, I returned home and noticed that my brake lights remained after I exited the truck. I tried turning the lights on and off, and they remained on. I decided to drive to the maxwell Chrysler dealer a few blocks away as I was afraid my battery would go dead. As I was proceeding down my street, I noticed the brake indicator light came on. I went to brake, and there was no brake pedal! it had fallen off. I made it to the dealership using my emergency brake. They said the "clasp" that holds the pedal had fallen off. It was not on the floor, so I don't know if it was broken, missing, etc. They replaced the clasp. I was horrified to think that I was supposed to have been on interstate I-35 towing my horses. Please look into this ASAP. I would like to know if this is an isolated incident, or whether this could be a possible defect.

See all problems of the 2005 Dodge Ram 2500 🔎.

Brake pedal goes too far down and it is positioned too close to accelerator pedal, causing an interference.

See all problems of the 2001 Dodge Ram 2500 🔎.