Brake Hoses, Lines/piping, And Fittings Problems of Ford Contour

Ford Contour owners have reported 7 problems related to brake hoses, lines/piping, and fittings (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Contour based on all problems reported for the Contour.

1 Brake Hoses, Lines/piping, And Fittings problem of the 1998 Ford Contour

Failure Date: 09/01/2014

1998 Ford Contour. Consumer writes in regards to vehicle brake line corrosion. The consumer stated the brakes the failed. The repair shop, stated there was no brake fluid in the reservoir. The consumer also stated the gas line leading to the tank had to be replaced, due to corrosion.

See all problems of the 1998 Ford Contour 🔎.

2 Brake Hoses, Lines/piping, And Fittings problem of the 1997 Ford Contour

Failure Date: 03/19/2007

The contact owns a 1997 Ford Contour. While driving 25 mph on 3/19/07 the driver felt something heavy fall on his foot and he began to lose control of the steering wheel. The steering column fell on the brake pedal and he couldn't stop the vehicle. The contact's vehicle crashed into a parked truck. The passenger side air deployed; however, the driver side didn't deploy. Two passengers in the vehicle suffered minor injuries to their knees and chests. The police officer stated that he never heard of a steering column breaking while driving. The contact stated in the state of wisconsin insurance was not required as she was uninsured. The service mechanic on 01/13/07 stated that the brake failure was due to the brake hose being loose. The failure mileage was with 158,000. The contact doesnt have the current mileage.

See all problems of the 1997 Ford Contour 🔎.

3 Brake Hoses, Lines/piping, And Fittings problem of the 1999 Ford Contour

Failure Date: 10/23/2002

Do to improper locating the rubber on the brake line unusual wear to rubber brake line. Have picture. Dt.

See all problems of the 1999 Ford Contour 🔎.

4 Brake Hoses, Lines/piping, And Fittings problem of the 1998 Ford Contour

Failure Date: 09/28/2000

Bracket that holds brake line into the rear part of the engine melted off or broke, causing no braking ability, which almost caused a crash. Currently will take to the dealer. Please provide further information.

5 Brake Hoses, Lines/piping, And Fittings problem of the 1997 Ford Contour

Failure Date: 05/17/1999

Upon inspection of the brake flux hose, there was a lot of friction abrasion due to improper installation of hose. The abrasion was so excessive that it thinned the hose to the inner liner, and when the brakes were applied the pressure caused it to burst, and lose all brake fluid and braking capabilities. The part and pictures are available if needed. The dealer charged $328 to fix the problem, but I feel that it should have been done at no charge, since it was clear that it was defective due to improper installation at factory.

6 Brake Hoses, Lines/piping, And Fittings problem of the 1996 Ford Contour

Failure Date: 07/01/1998

Brakes and brake line failed.

See all problems of the 1996 Ford Contour 🔎.

7 Brake Hoses, Lines/piping, And Fittings problem of the 1999 Ford Contour

The vehicle had poor gas mileage. The drivers window jammed. The rubber piece around the frame of the right side rear passenger's seat constantly came off. The shoulder harness on driver's side and in the rear seats twisted and jammed. The dashboard cover came loose. The radio operated poorly. The trunk latch often required multiple pulls to open the trunk. The air bag light intermittently came on. While driving there was a whining/grinding noise.


Other Common Service Brakes related problems of Ford Contour



Fuel Economy of Contour Vehicles
Contour Service Bulletins
Contour Safety Recalls
Contour Defect Investigations