Four problems related to brake sensor have been reported for the 1999 GMC Yukon. The most recently reported issues are listed below.
The contact owns a 1999 GMC Yukon. The contact stated that while applying the brake the vehicle slowed to approximately 3 mph but did not come to a stop. The dealer was notified and informed him that based on the information given there was corrosion on the brake sensor that caused the failure. The vehicle had not been repaired. The failure and current mileage was 120,000.
The contact owns a 1999 GMC Yukon. The contact is experiencing issues with the abs sensor on his brakes. While driving various speeds, the vehicle vibrates or the brake pedal extends to the floor when it is depressed. The dealer stated that the vehicle was not under recall; therefore, the contact would have to pay for the abs sensor repair. The failure mileage was 114,500. Updated 05/26/09 updated 05/28/09.
The contact stated at low speeds the abs system engages and he cannot stop the vehicle easily. The first time he noticed the problem was 4-04-2004. On 6-21-2004 he had the brake sensors cleaned and other repair work done. A couple of weeks ago he experienced the same problem with the brakes. He talked to the dealer and to gm ,and they informed him that this vehicle was not included in recall #05v379000 due to VIN.
Consumer's 1999 GMC Yukon is experiencing problem related to campaign number 05v379000. The consumer stated he has been experiencing problems with the abs for the past 10 years. The sensors were replaced twice. There were several attempts to get GMC to repair the problem, but with no success since the actual recall did not list the consumers make, model and year on the recall. The consumer stated there is an obvious defect.