Two problems related to front suspension hub have been reported for the 2003 Jeep Liberty. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2003 Jeep Liberty based on all problems reported for the 2003 Liberty.
A recall was made for Jeep Liberty for the control arms upper and lower and the ball joints. I was told my VIN did not have the recall. However, others had the recall and Jeep paid for the repairs. After the repairs the wheel hub went bad, and a recall was made for that but not my basic model. After replacing the wheel hub the driveshaft was damaged by all the issues. A recall for the same vehicle was made for a driveshaft and again the bass model was not included in the recall. This time Jeep said they would fix the driveshaft and when it came time they denied it.
The contact owns a 2003 Jeep Liberty. The contact received recall notice#06v288000: suspension:front:control arm:lower ball joint in February. The mechanic stated that there was damage to the tie rod and steering knuckle. The dealer stated that they would repair the vehicle at no charge; however, they advised her at the appointment that she was responsible for paying $600 to repair it. The dealer also stated that the recall repairs are only related to the lower ball joints. The failure mileage was 77,000 and the current mileage was 77,310. The dealer stated replaced left outer tie rod, left knuckle, wheel speed sensor, and fixed hub assembly. The consumer provided invoices of repairs for vehicle. Updated 07/05/07.