Brake Abs Warning Light Problems of Jeep Liberty

Abs light keeps going off even when brakes and rotors has been replaced . Brakes will skip or make a shaking vibration on the pedal when press and makes it hard to stop or impossible while in motion rather driving in the city or on the highway.

See all problems of the 2006 Jeep Liberty 🔎.

Tl-the contact owns a 2006 Jeep Liberty. The contact stated that an independent mechanic diagnosed that the undercarriage had rusted extensively. The abs sensor lights remained on because the undercarriage was sagging toward the tires setting off the sensors . The mechanic stated that when he touched the undercarriage rust fell off in his hands. The mechanic refused the fix the vehicle and referred the contact back to the manufacturer. The manufacturer stated that there was an open recall on the issue in 2012 that then shut down. The manufacturer did not confirm any recalls when given the VIN by the contact. The contact is the original owner of the vehicle and VIN tool showed no recalls at this time. The manufacturer referred the contact to call NHTSA to file a complaint. The contact had not been contacted at this time. The failure mileage was 94,000. Tf.

10/20/17 driving 5 minutes & brakes locked - Jeep wouldn't move at all - after 20 minutes Jeep ran normally for 3 weeks; 11/9/17 driving grandbabies home - going 40 on a major highway - brakes again lock up Jeep came to a stop & would not move forward and would not reverse - esc indicator light on, esc off appeared in the odometer and the abs light was on - the smell of brakes was overwhelming - called aaa for a tow - after an hour - all sorts of creaking noises could be heard - ? brakes releasing - was then able to drive the Jeep - cancelled aaa - drove Jeep immediately to my mechanic - after 2 days he could not figure out what the problem is nor could the issue be duplicated ; called the Jeep dealer that I bought it from on essington Ave in philadelphia - they said they had never heard of this issue - to bring the Jeep in to be "diagnosed" for $115. 00 - when asked for a loaner - they told me I'd have to pay for a rental - there are 55,000 miles on the Jeep.

See all problems of the 2011 Jeep Liberty 🔎.

The contact owns a 2005 Jeep Liberty. While driving over a bump at approximately 40 mph, the vehicle suddenly began to shake and vibrate when pressing the brake pedal. The contact indicated that the abs sensor light later illuminated. The cause of the failure was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 124,547.

See all problems of the 2005 Jeep Liberty 🔎.

The contact owns a 2007 Jeep Liberty. The contact stated that after starting the vehicle, the abs warning light illuminated. The vehicle was not diagnosed or repaired. The manufacturer stated that the vehicle was not included in NHTSA campaign number: 06v493000 (service brakes). The failure mileage was 128,000.

See all problems of the 2007 Jeep Liberty 🔎.

Esp bas abs lights keeping coming on and pulling to one side occasionally for unknown reason while lights are on. Numerous reports of the same problem on the internet from other 2006 Jeep Liberty owners.

Same gas problem it overflows tank when filling it. Abs light, esp bas, and traction control lights came on and brakes go all the way to the floor at times. Window regulators keep going out making my vehicle unsafe for me to put my child in. As a single parent I cannot afford to keep paying for costly repairs (mainly the windows) to prevent my child from getting sick in wisconsin winter. I do not have time in my day to sit and wait on repairs to be done. I hate risking frost bite when my window decides to fall and I'm trying to hold it up! it is now snowing and my drivers side window has fallen into my door yet again and it is 2 am and I really hope garbage bags keep it dry!.

After sitting at a red light, I attemped to pull off from the stop, the abs light and the tracktion control light came on and the rear brakes locked up. I was a mile from home, I put the vehicle in four wheel drive in order to get it to move. I drove one mile to my home and parked, I could smell the brakes. I let the vehicle sit for approximately one hour, tried to drive it and it operated as if nothing had happened. I drove the vehicle again the next day with no problems.

The esp bas, traction control, and abs lights come one randomly. . . Could be driving, in park, going 20 mph. . . Has been going on now since April. . . Dealership says they cant do anything unless the lights are on/active. . . This morning my brakes tried to give out on me and it really scared me. . . I am a mother and need to trust that I paid for a reliable vehicle. . . After reading about 30 different forums I am not the only one that is having this problem. . . This needs to get fixed immediately please.

The contact owns a 2002 Jeep Liberty. The contact stated that the abs warning light illuminated as the vehicle was started. The vehicle was not taken to the dealer. The manufacture was contacted and they stated there were not any recalls for the vehicle. The failure mileage was not available and the current mileage was 130,000.

See all problems of the 2002 Jeep Liberty 🔎.

While traveling on the highway at approx 55-60 mph, driver depressed brakes to quickly slow down to avoid the car in front which had slowed and was turning. Rear brakes on vehicle locked causing vehicle to screech, tires to smoke and vehicle to spin around in a circle and cross center line on the highway. It was a clean, dry highway at approx 5:45 pm. Fortunately, there were no other vehicles in the area besides the one in front. Had an automobile been behind the vehicle, it would have resulted in a crash. Driver was able to drive away from the scene. Abs light came on after the incident, but did not illuminate when vehicle was started the next time about 2 hours later. Abs light was not on prior to the incident. Vehicle has not been operated since it was re-started 2 hours after incident and driven about 6 miles home.

In response to all the complaints of abs light and brakes feeling like they won't work. . . . . . I had this problem and was at the dealership a lot over the last 2 years. It turned out to be a burnt wire!!! I have not had any problems in the last 3 months(which is a long time for this car)!!!!!!!!!!. Please tell your mechanic to check the brake sensor (abs sensor) wires!!.

The contact owns a 2007 Jeep Liberty. While driving approximately 50 mph, the abs light illuminated on the instrument panel. When the driver approached a stop sign, she noticed that the brakes were not working properly. The brakes then completely failed and the vehicle felt as if it were accelerating, causing her to crash into another vehicle. A police report was filed. The vehicle was still able to be driven, but the brakes barely work. The manufacturer stated that the VIN was not included in the recall. The recall number was unknown. The current and failure mileages were approximately 9,000.

When the brakes were applied, abs light illuminated on the dashboard.

If the car is stopped on a hill the brakes will seize up. The traction control and abs lights will stay on. It takes about a day for the brakes to release. This can happen while driving as well. It has happened 5 times. The systems can also be reset by pulling the abs fuses. The vehicle will not move while the brakes are locked. This has happened on the highway and the middle of the road.

Vehicle has abs failure when driving on wet roads. This results in lost of brake and power steering.