Mazda MAZDA6 owners have reported 2 problems related to tank filler pipe and cap (under the gasoline fuel system category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Mazda MAZDA6 based on all problems reported for the MAZDA6.
The contact owns a 2009 Mazda 6. While driving 70 mph, the loose fuel cap warning light illuminated. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was 105,000.
See
all problems of the 2009 Mazda MAZDA6
🔎.
Car engine stopping while running and a no start. Service engine light warnings over a long time. One repair by Mazda on the gas cap repair, but I have also uncovered a recall on leaking seals at the tank on 2003 models, 03v-531. Service light again came on from 10/18/10 -10/30/10. While out of town the car sat airport parking on my return it stopped without warning at a light 11/22/10, but all lights and radio stations were active, so no battery problem. After adjusting the filler gas cap several times I found it wasn't closing and could be pulled right off. We have made sure the cap is on tightly each time and since canncelled the dealer appointment for a $100 inspection, no light since. 2/9/11 after driving 35 miles the car would not restart, aaa came out and no battery trouble, but a 30 mile towing was required to my home. The vehicle sits in a garage avg temp of 35-45f. The next morning affter several attemps and using both keys it restarted and we took it into a dealer. @2 days later tehy find a "service bullitin" 901-009/07) from 2007. Possible @ -30c (zerof) the no start or crank due to moisture within the main relay and/or fuel pump relay. That night 25-30f in Nov no way close. On 02/12/11 while driving on is77 the car quite running again, 911 called as I made it to the side of the road under heavy fast moving traffic. This week on 2/22 while in the garage hesitant to turn over again but did start on the 3rd try, vehicle temp reading was 47f. So now for 2 new parts for 2003-2005 models and $450+ repairs can be made. The parts are in and per the bulletin looks more like a by-pass option than replaceing a defective oem part. Cutting out while driving is very serious, as much so as acceleration on a Toyota. Since my company is tied to the tire/wheel & auto mfg and we conduct 1/2 dot tire test for the USA, I'm pretty sure I know what I'm talking about on defects.
See
all problems of the 2003 Mazda MAZDA6
🔎.
Problem Category | Number of Problems |
---|---|
Gasoline Fuel System problems | |
Tank Assembly problems | |
Fuel Pump problems | |
Fuel Hoses Lines/piping And Fittings problems | |
Fuel Injection problems | |
Tank Filler Pipe And Cap problems | |
Fuel Delivery problems | |
Tank Mounting problems |