Wiring Problems of Oldsmobile Cutlass

Oldsmobile Cutlass owners have reported 2 problems related to wiring (under the electrical system category). The most recently reported issues are listed below.

1 Wiring problem of the 1997 Oldsmobile Cutlass

Failure Date: 06/10/2003

The vehicle's iac sensor connector wire was too short which caused engine failure while driving. Technical service bulletin 634780 is related to this issue.

See all problems of the 1997 Oldsmobile Cutlass 🔎.

2 Wiring problem of the 1999 Oldsmobile Cutlass

Failure Date: 12/10/1999

Vehicle was parked & the lights remained on. Took foot off accelerator pedal & lights became dimmed. Took vehicle to dealership & mechanic replaced the light wiring to keep lights from staying on.

See all problems of the 1999 Oldsmobile Cutlass 🔎.

Other Common Electrical System related problems of Oldsmobile Cutlass

Problem Category	Number of Problems
Anti-theft Controller problems	14
Ignition Switch problems	10
Electrical System problems	9
Horn Assembly problems	6
Alternator/generator/regulator problems	5
Dash Wiring problems	5
Ignition problems	5
Ignition Module problems	4
Car Will Not Start problems	4
Underhood Wiring problems	3

Switch Make:

Switch Model:

✿ Fuel Economy of Cutlass Vehicles

☘ Cutlass Service Bulletins

⚑ Cutlass Safety Recalls

☤ Cutlass Defect Investigations