Electrical Jack Problems of Toyota Camry

Toyota Camry owners have reported 7 problems related to electrical jack (under the equipment category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Toyota Camry based on all problems reported for the Camry.

1 Electrical Jack problem of the 2015 Toyota Camry

Failure Date: 09/26/2019

Tl-the contact owns 2015 Toyota Camry. The contact stated that while chanign his tire he noticed the handle for the jack was too short. The contact try to remove the nutts to replaced the tire and was unable to reach the nuttsz due to the handle begin to short. The dealer south coast Toyota 1966 harbor blvd, costa mesa, CA 92627 (949) 722-2000 was contacted and made aware of the failure but informed the contact that the jack that came with the make and model of the vehicle had to be discus with Toyota manufacturer. The manufacturer was made aware of the failure but no further assistance was taken. The contact mendsion that he would need a extension tool inorder for the jack to be used property. The failure mileage was approximately 45,296. Ck.

See all problems of the 2015 Toyota Camry 🔎.

2 Electrical Jack problem of the 2010 Toyota Camry

Failure Date: 09/14/2019

The dashboard is breaking down and has become very sticky. This causes glare when driving at night that is a safety issue. I called Toyota about it on 9/14/209, but they said their 'warrant enhancement' expired on 8/13/2019. Toyota said that they sent a letter in 2016, which I never received. I had my car serviced at a Toyota deal (jack taylor Toyota, alexandria va), and they never notified me of the 'warranty enhancement. ' they said that they only had to notify for recall safety issues. They said that they could replace it for @2,171. 46 this is a safety issue and this should be a recall, not just a 'warranty enhancement. ' Toyota's methods to notify are inadequate and this problem is ongoing - me and many others will have this safety problem beyond Toyota's warrant period. Especially since they do such a poor job of customer notification. This causes a lot of road glare at night and will cause accidents and deaths. Toyota is obviously not doing the right thing on their own. I hope the ntsb can please advance a recall for this issue.

See all problems of the 2010 Toyota Camry 🔎.

3 Electrical Jack problem of the 2009 Toyota Camry

Failure Date: 08/01/2018

The factory provided vehicle jack is of poor quality. It bent from the middle after the very first use. If not for the tire still on the axel, the car would've had lots of damage.

See all problems of the 2009 Toyota Camry 🔎.

4 Electrical Jack problem of the 2007 Toyota Camry

Failure Date: 03/15/2016

/c problems. The service guy stated the problem was not with work Toyota did on the car. It has been one thing after another. I love my Toyota. This is lousy service. I know it has been quite some time since all of this was done. I just have not felt up to voicing my complaint. Unhappy with Toyota service at herrin gear Toyota in jackson, ms.

See all problems of the 2007 Toyota Camry 🔎.

5 Electrical Jack problem of the 2012 Toyota Camry

Failure Date: 11/28/2015

I purchased the car from a dealership in jacksonville, florida. After I signed papers and wanted to take the car home I have noticed a sticker closed to the drivers door, it says Toyota motor corporation, authorized modification, the following modifications has been made (and then with a red marker it is written dot recall) and underneath of it continue, these modifications have been approved as appropriate by epa and carb. Dealer code 09231. Date 3/19/14. I do not know what this means, was car on recall by dot and was/were the issue/issues resolved or not. Can you help. Contact me at 904-345-9096.

See all problems of the 2012 Toyota Camry 🔎.

6 Electrical Jack problem of the 2012 Toyota Camry

Failure Date: 07/22/2013

Flat tire in home garage. Oe pantograph (scissor) jack was used in attempt to raise car. Excessive torque was necessary to begin lift, up to limit of flimsy jack handle. As vehicle neared top of necessary lift, jack flipped over sideways and was propelled out from under car with some force. Car fell. No injury or damage because I observed all safety precautions while lifting. Jack is flimsy, too small for the car, and has much too small a base. This occurred on level concrete floor. Markings on jack include: 2j141, 2012, and made in canada.

7 Electrical Jack problem of the 2005 Toyota Camry

Failure Date: 06/29/2012

The contact owns a 2005 Toyota Camry with a 2009 Toyota towing hitch kit. The contact stated that the front passenger side tire was raised by the jack in order to change a flat tire. The jack bent abnormally, causing the vehicle to fall abruptly. The contact stated it was the first time she used the jack. The dealer was made aware of the failure and advised the contact that the jack may have been installed incorrectly. The technician offered to replace the jack with another one of the exact model. The jack was not replaced. The failure mileage was unknown. The VIN was not available.

See all problems of the 2005 Toyota Camry 🔎.




Safety Ratings of Camry Cars
Fuel Economy of Camry Vehicles
Camry Service Bulletins
Camry Safety Recalls
Camry Defect Investigations