Toyota Highlander owners have reported 2 problems related to brake disc rotor (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Toyota Highlander based on all problems reported for the Highlander.
The contact owns a 2003 Toyota Highlander. The contact stated that Toyota is placing new brake pads on vehicles which last longer, but get so hot that they warp the vehicle's rotors. She stated that formerly it would cost $60 to replace the brake pads, but now it costs $300, not including the replacement of the warped rotors. The warped rotors cause the steering wheel to shake uncontrollably when applying the brakes at 60 mph or greater. The current and failure mileages were 58,400. On September 14, 2007, during an oil change,the dealer checked the tire tread and brake pads and the brake pads are operating normally. The contact stated that the vehicle is still shaking at 50mph because the rotors are damaged due to the front brake pads. The dealer and mechanic stated that the newly designed brake pads dont wear as fast; however, it causes friction and the rotors to warp. The front brakes were replaced in April. The dealer stated on the invoice that the rear brakes are operating normally. The contact is aware of the safety risk involved. Updated 02-01-08. The consumer also stated there is a sever issue concerning the seats. The consumer stated she has experienced extreme hip and back pain from the seats. The consumer stated she can't adjust the seat anymore, because then she will not be able to reach the steering wheel.
See
all problems of the 2003 Toyota Highlander
🔎.
Frequently when the brake pedal was depressed the pedal went to the floor, which caused the brakes not to stop immediately in a panic or emergency situation. Dealership indicated that this was normal for the brake system for this vehicle. Three different mechanics inspected the brake system, and determined that the master cylinder was not functioning correctly. The master cylinder needed to be constantly replenished with brake fluid. Also, the brake system had to be bled because air got in it. Dealership indicated that the brake system was designed for a passenger vehicle and not an SUV. Repairs were also performed on vehicle due to premature wear on pads and rotors, and on vehicle's front door weather stripping due to premature wear. Recall#01v228000. The brake problem had been a problem since purchase.
See
all problems of the 2001 Toyota Highlander
🔎.