Toyota Tacoma owners have reported 3 problems related to brake abs warning light (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Toyota Tacoma based on all problems reported for the Tacoma.
After driving on the highway for a few minutes at ~70 mph, the abs light run red on. When the light turned on the computer thought the car was in a bad situation and locked the brake pedal. This caused the brakes to not function and made the car almost impossible to stop. Whenever the car was able to be slowed down to about 19 mph, the light would turn off and the brakes would start to function normally. This happened once a week for 3 weeks in 2015 and again in February of 2016. It happened again in April 2016. This problem did not happen at low speed and it would not happen twice in the same day, even during the same conditions. I went to wolfchase Toyota to fix the problem. They decided not to do anything about it. I went to principal Toyota and they said they had never seen the problem before. They said that they could reset the computer or put in a new one ($3000). They reset it and for the past few months it has worked.
See
all problems of the 2007 Toyota Tacoma
🔎.
Abs light came on went off then came back on and stayed on. Toyota took three hours to figure it out. Abs control modual ( abs cpu ).
See
all problems of the 2002 Toyota Tacoma
🔎.
The contact owns a 2010 Toyota Tacoma. While driving approximately 60 mph, the abs light illuminated and the vehicle stalled. The failure recurred numerous times. The vehicle was taken to the dealer for diagnostic testing, but the results were unknown. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 20,000.
See
all problems of the 2010 Toyota Tacoma
🔎.