Wiring Problems of Buick Lucerne

After being driven normally all day, the car all of a sudden wouldn't crank properly after being parked for a few hours. The car needed to be towed to a car shop. According to a local mechanic, the back seat pressed on the wiring that, in turn, burned up the electric panel and the fuel pump. Due to this, the electric panel and the fuel pump need to be replaced.

See all problems of the 2009 Buick Lucerne 🔎.

The contact owns a 2011 Buick Lucerne. While driving 60 mph, the engine stalled and the steering wheel seized without warning. It took the contact several minutes to restart the vehicle. The failure occurred on several occasions and, each time the vehicle stalled, the contact was locked inside the vehicle due to the electronic lock system within the vehicle. The vehicle was not diagnosed nor repaired. The contact serviced the vehicle himself and found that the wiring harness had melted and the engine warning indicator illuminated. The manufacturer was notified. The failure mileage was 118,000.

See all problems of the 2011 Buick Lucerne 🔎.

I lost engine power as I was driving on i75 approximately 16 miles south of venice florida. One of the tires exploded and the whole wiring system was destroyed due to the tire explosition, as well as the back bumper. My vehicle was towed to bhe Buick dealer in venice florida. Repair costs including towing and rental car for the period my vehicle was being repaired elevated to approximately $1600. 00. This does not include replacement of the back bumper which would cost an additional $1400. 00 per Buick's quote. I was informed of a recall by Buick due to the exact reasons that led to my accident and related costs. General motors is declining responsibility whereas I did experience the problems listed in the reasons for recall number 14299.

See all problems of the 2006 Buick Lucerne 🔎.

2007 Buick Lucerne with safety issue concerning the wiring. The wiring harness in the engine compartment was found to be in contact with the pulley on the air conditioner compressor. The pulley perforated the wire causing the copper conductor to have contact with the pulley.

See all problems of the 2007 Buick Lucerne 🔎.

Failure info unknown. The panel instruments are not visible during daylight hours while the headlamp switch is in the "auto" position. In "park" and "headlight" position the panel lamps are on. A very simple wiring change can correct this and make the speedometer and gauges visible.