Wiring Problems of Chevrolet Corvette

1) check airbag warning light turns on intermittently when adjusting drivers seat. Faulty wiring in seat wiring harness. 2) check airbag warning light turns on when driving on highway or when parked. Moving seat back, forward, up/down will clear the check airbag warning light, but warning returns. 3) recurring issue on multiple days.

See all problems of the 2010 Chevrolet Corvette 🔎.

The contact owns a 2007 Chevrolet Corvette. The contact stated that the headlights suddenly shut off without warning. In order to turn the headlights back on, the contact had to cap the fuse box. The dealer stated that the wiring shortage was under the fuse box and the vehicle needed to be rewired in order to prevent the shortage. Also, the fuse box needed to be replaced. The manufacturer stated that the vehicle had already received a recall repair regarding the headlights. The contact stated that the failure recurred even after receiving the repair. The recall details were unknown. The approximate failure mileage was 109,000.

See all problems of the 2007 Chevrolet Corvette 🔎.

The hazard switch is faulty. All of the wiring for the brake and turn signals goes through the hazard switch. Every Corvette forum details the faulty hazard switch. Because of the poor quality of the part, and the poor design of the electrical system, if the hazard switch malfunctions, there are no brake lights, and/or no turn signals or hazard lights. There is no indication that the switch is malfunctioning until another motorist notifies you verbally or by crashing into you, or perhaps if law enforcement pulls you over for it.

See all problems of the 2000 Chevrolet Corvette 🔎.

When car gets hot, the low beam lights will not turn on. There is an existing recall for Corvette c6 models from 08-13. But there are none for Corvette c6 z06 models from 08-13 even though the fusebox, headlight wiring is identical.

See all problems of the 2008 Chevrolet Corvette 🔎.

Owner of 2007 Corvette coupe. Vehicle headlights went completely out while driving on the freeway. The next day headlights worked until the car was warmed up then failed agin. After reviewing online Corvette forum there were many many complaints of the problem which is attributed to the faulty wiring inside the fuse box under the hood. Had to replace the fuse box at a cost of $400. But this issue will likely re occur because the new fuse box will develop the same problem over time since it has not been redesigned.

Made online concern and issue with low beam lights going off in 2011. Recall notice from gm; January 2015, states it will install "jumper" wire. I already had this completed on 10/13/2011 which resulted as a short term fix. Still ended up having problems and eventually (hoping for the recall to transpire sooner) have it set up now where I need to pop the hood and install a 20 amp fuse in order for lights to go on. "jumper" format is not adequate just be aware. The design of the ubec unit should be overhauled to accomplish two key issues; heat and less sharp bends of the internal copper wiring to prevent stress and breaking. Currently only fog lights function without having to plug in the 20 amp fuse. Even my bright lights need the fused plug in under the hood.

I've had repeated failures that have required multiple repairs 1. Engine knocking- repeated repairs, upper end replaced knocking and engine roughness still there 2. Transmission- failure of clutch plates, replaced problem not resolved, transmission slipping is increasing 3. Electrical system failure: the electrical system completely shuts down, nothing operates even the hazard warning lights- this has occurred a minimum of 8 times. Relays, switches wiring battery get extremely hot until battery bleeds down. High potential for electrical fires and car cessation of operations have left us in perilous conditions on multiple occasions.

No high beam head lights. Fuse did not blow, bulbs checked and are good, but will not light. Had checked, and found short in wiring harness and fuse box. Dealer will not repair.

: the contact stated while the vehicle was parked, the steering wheel locked and the digital wait ten seconds and remove key light illuminated. After following the digital display command, the steering wheel remained in the locked position. The vehicle was towed to a dealer who determined the wiring harness, steering module, and lock plate needed to be replaced. Additionally, the computer code was reprogrammed. After these corrections were made, the problem persisted. The manufacturer was alerted.

See all problems of the 1999 Chevrolet Corvette 🔎.

The engine light illuminated, the dealership indicated the ac delco battery leaked acid all over the wiring harness.

See all problems of the 1998 Chevrolet Corvette 🔎.

Vehicle caught on fire in garage due to electrical fault in factory wiring. Fire originated on driver's side of engine compartment.

See all problems of the 1996 Chevrolet Corvette 🔎.