Chevrolet S10 owners have reported 4 problems related to brake antilock control unit/module (under the service brakes category). The most recently reported issues are listed below.
Abs system turned on out of nowhere when the roads were perfectly clear causing me to run into a shrub, abs system light came on and the abs system does not work anymore.
See
all problems of the 1998 Chevrolet S10
🔎.
: the contact stated after purchasing a used vehicle that already had the abs light illuminated, the abs engaged at speeds of 10mph or less. The vehicle was inspected by the dealer. The entire abs control module was replaced. Afterwards the problem continued, but no further repairs were made.
See
all problems of the 2000 Chevrolet S10
🔎.
While driving at a low speed, about 5 mph, owner went to a fast food line and pushed the brakes and the pedal was stiff. There was a pulsation in the brakes, and extended stopping was required. Owner had to pull out of line to keep vehicle from hitting the car in front. The owner then pushed the brakes, and they worked just fine. The problem only occurred when the owner was going at slow speeds. The problem happened in all weather and road conditions. The owner was aware that there was a known problem with the abs sensor, and was wondering when the recall will take place.
Abs motor continues to run after engine has been shut off.