Chrysler Sebring owners have reported 5 problems related to automatic transmission gear indicator (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chrysler Sebring based on all problems reported for the Sebring.
- the contact was at a stop with the gear in park; when she applied the accelerator pedal the gear shifted to neutral. This incident has occurred on two occasions. The contact has researched similar complaints on the NHTSA website related to the 2002 Chrysler Sebring. The contact's mechanic stated the failure is due to a failure in the drive shaft. The contact's vehicle was taken to the mechanic on December 18, 2006 for repair. The power train is under warranty.
See
all problems of the 2002 Chrysler Sebring
🔎.
Since vehicle was purchased the gear shift has been hard to put into gear. There are grinding noises and it shakes. When this occurs the check engine light comes on. Vehicle was taken to the dealer numerous times. The dealer said they were unable to find anything wrong. Had not contacted the manufacturer. The consumer stated wires and hoses were replaced because of rodents.
See
all problems of the 2005 Chrysler Sebring
🔎.
Consumer received a recall letter, dealing with the gear shift. Consumer took the vehicle to the dealer to have the recall fixed. However, gear shift could still be moved without the key being inside the ignition.
See
all problems of the 1998 Chrysler Sebring
🔎.
Vehicle was in park and without prior warning consumer's son kicked the gear shift and vehicle went into drive, resulting in a front end collision, vehicle hit a tree.
See
all problems of the 1997 Chrysler Sebring
🔎.
Gearshift lock failed causing vehicle to roll uncontrollably.
See
all problems of the 1996 Chrysler Sebring
🔎.