Chrysler Sebring owners have reported 3 problems related to axle shaft (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chrysler Sebring based on all problems reported for the Sebring.
: the contact stated the vehicle was taken to the dealership because there was a loud rumbling noise coming from the right front side of the vehicle. The dealership determined the right front axle was defective due to the poor quality of the material. The right front axle was replaced. Within 1,000 miles later, the noise and the vibration returned on the right front side of the vehicle. The dealership determined the left front axle was also defective and replaced the left front axle. The consumer stated there is still a noise present. Updated 08/14/06.
See
all problems of the 2002 Chrysler Sebring
🔎.
Right rear wheel bearing assembly is bad. Consumer can jiggle it all over the place this is very unsafe for family while riding in the car.
See
all problems of the 1996 Chrysler Sebring
🔎.
Wheel bearing was defective, causing wheels to fall off. Convertible top blew open while driving at 55 mph, after the top rails of the vehicle had been adjusted by the dealer to correct the noise problem from the wind. . Et.
See
all problems of the 1997 Chrysler Sebring
🔎.